This appliance complies with European Economic Community Radio Interference Directive
89/336/EEC.
Place the sealing ring on the recess of the Blade Hub Assembly (Fig. 1) ensuring that it is correctly
located. Position the Blade Hub Assembly with sealing ring into the base (Fig. 2). Screw the goblet
into the base in a clockwise direction until firmly located (Fig. 3). Ensure the lid washer is correctly
positioned in the lid recess, then fit the filler cap. For glass goblets locate the lid by turning it in a
clockwise direction (Fig. 4). For stainless steel goblets push the lid firmly down to locate.
Place the blender onto the power unit engaging the lugs in the base in the slots provided. Turn the
blender clockwise until it locks into position. Turn anti-clockwise to remove.
Connect the appliance to the power supply. Press the green button to switch on the blender and to
stop the appliance press the red button. Your blender has two speeds. Select the lower speed for
lighter blending e.g. milk shakes and the higher speed for harder tasks e.g. pâtés etc.
Safety Note
Your blender incorporates a safety device and should the power to the appliance be interrupted, it
will not re-start with the resumption of the power without first pressing the green start button.
To wash and ‘run in’ your blender, fill with warm water, place onto the unit and switch on for 20-30
seconds. Remove from the power unit, empty out the water and dry. The blender is now ready for
use.
Hint
To ensure that there are no leaks from the base, grip the handle and turn the blender when in place
on the power unit. After use the goblet may be loosened from the base in the same way, but always
ensure that the goblet has been emptied of food first. Wetting the sealing ring will also help to
prevent the odd case of leakage.
IMPORTANT
For safety reasons we do not recommend the blending of very hot liquids.
Do not leave the blender soaking with water in the goblet and do not leave the blade assembly
soaking in water.
The blender runs at such high speeds that all foods are processed within one minute. Prolonged
running should be avoided especially when processing dry ingredients or small quantities. When
switching off wait until the blades have stopped revolving before removing the blender. If you do not
do this you will damage the coupling of the blender.
The blender goblet is not suitable as a storage container therefore ingredients should not be left to
stand in the goblet before processing and should be removed immediately afterwards.
Operating the Blender
Using your Kenwood Blender
Connecting to power
Before switching on make sure that the voltage of your electricity supply is the same as
that indicated on the rating plate.
IMPORTANT (UK ONLY)
The wires is the mains lead are coloured in accordance with the following code:
BLUE
NEUTRAL
BROWN
LIVE