Kenwood NEXEDGE NX-820 Скачать руководство пользователя

Страница: 4 / 127

NX-820

3. PLANNING THE INSTALLATION
3-1. General

Inspect the vehicle and determine how and where the ra-

dio antenna and accessories will be mounted.

Plan cable runs for protection against pinching or crush-

ing wiring, and radio installation to prevent overheating.

3-2. Antenna

The favored location for an antenna is in the center of a

large, flat conductive area, usually at the roof center. The
trunk lid is preferred, bond the trunk lid and vehicle chassis
using ground straps to ensure the lid is at chassis ground.

3-3. Radio

The universal mount bracket allows the radio to be

mounted in a variety of ways. Be sure the mounting surface
is adequate to support the radio’s weight. Allow sufficient
space around the radio for air cooling. Position the radio
close enough to the vehicle operator to permit easy access
to the controls when driving.

3-4. DC Power and wiring

1. This radio may be installed in negative ground electrical

systems only. Reverse polarity will cause the cable fuse
to blow. Check the vehicle ground polarity before installa-
tion to prevent wasted time and effort.

2. Connect the positive power lead directly to the vehicle

battery positive terminal. Connecting the Positive lead to
any other positive voltage source in the vehicle is not rec-
ommended.

3. Connect the ground lead directly to the battery negative

terminal.

4. The cable provided with the radio is suffi cient to handle

the maximum radio current demand. If the cable must be
extended, be sure the additional wire is suffi cient for the
current to be carried and length of the added lead.

4. INSTALLATION PLANNING – CONTROL STATIONS
4-1. Antenna system

The antenna system selection depends on many fac-

tors and is beyond the scope of this manual. Your KEN-
WOOD dealer can help you select an antenna system that
will best serve your particular needs.

4-2. Radio location

Select a convenient location for your control station radio

which is as close as practical to the antenna cable entry
point. Secondly, use your system’s power supply (which sup-
plies the voltage and current required for your system). Make
sure suffi cient air can fl ow around the radio and power sup-
ply to allow adequate cooling.

SERVICE

This radio is designed for easy servicing. Refer to the

schematic diagrams, printed circuit board views, and align-
ment procedures contained in this manual.

3. 安装的步骤
3-1. 概述

检查车辆并确认如何以及在何处安装无线电天线和附件。
安排好电缆的位置，避免挤压或碾碎布线，同时无线电设

备避免过热。

3-2. 天线

天线的最佳位置应该在一个宽阔，平整导电区域的中心，

通常在车顶的中心。行李箱的盖子更好，将地线黏结在行李
箱的盖子和车辆的外壳上确保行李箱盖子接地。

3-3. 无线电设备

通用安装托架允许以多种方法安装无线电设备。确认安装

的表面足以支撑无线电设备的重量。无线电设备的周围留出
适当的空间进行散热。将无线电设备尽可能的安装在靠近车
辆操作者的位置上，以便在驾驶时易于控制。