Installation Procedure
Accessories
6 English
English
1. To prevent short circuits, remove the key from
the ignition and disconnect the · terminal of the
battery.
2. Make the proper input and output cable
connections for each unit.
3. Connect the wiring harness cables in the
following order: ground, ignition.
4. Connect the wiring harness connector to the
unit.
5. Install the unit in your car.
6. Reconnect the
-
terminal of the battery.
• This product is intended for use with 12V DC
negative ground power only. Do not connect it
to any other power supply
• To prevent shorting, disconnect the battery
cable from the negative terminal of the battery
during installation.
• Be sure to firmly stabilise this product. Do not
install it in a location which is not stable.
• Follow the installation and wiring procedures
described in this manual. Improper wiring or
modified installation can not only result in
malfunction or damage to the unit but may also
result in an accident.
•
Do not install the unit in the following
locations.
• A location which interferes with the operation
of the air bag system.
• A location which is not made of plastic.
\
Installing on leather, wood or cloth may
damage the surface.
• A location subject to direct sunlight, subject to
the air from the air conditioner, or subject to
moisture or high temperature.
\
This may cause deformation of the monitor
unit.
•
Be sure to use the supplied screws for
installation.
Using screws longer than those supplied may
destroy parts inside the unit causing it to
smoke. Using screws shorter than those
supplied may cause the unit to come looks from
the installation bracket.
• If you are not going to install the unit using the
supplied monitor stand, be sure to use a
commercially available monitor stand. (Mounting
holes for such a stand are located on the bottom
of the monitor unit.)
• If your car's ignition does not come with an ACC
position, connect the ignition cables to a power
source that can be turned on and off with the
ignition key. If you connect the ignition wire to a
power source that receives a constant voltage
supply, as with battery cables, the battery may
die.
• If the fuse blows, first make sure that the cables
have not caused a short circuit, then replace the
old fuse with one with the same rating.
• Do not let unconnected cables or terminals
touch metal on the car or anything else
conducting electricity. To prevent short circuits
do not remove the caps from unused terminals
or from the ends of the unconnected cables.
• After the unit is installed, check whether the
brake lamps, blinkers, wipers, etc. on the car are
working properly.
• Insulate unconnected cables with vinyl tape or
other similar material.
• Thoroughly wipe away oil and other dirt from
the installation surface. Please avoid installation
on uneven surfaces.
2
CAUTION
2
WARNING
Installation
A
E
B
(Ø4 x 12 mm)
D
C
The use of any accessories except for those provided might result in
damage to the unit. Make sure only to use the accessories shipped
with the unit, as shown above.
LZ-651W_ENG r2 03.7.25 9:50 AM Page 6
