Continue steps 3 and 4 until all the characters are chosen for
the name.
You can enter up to eight characters for each name.
Assigning Names
Press the NAME.S button.
The name of the station is stored in memory, and the Station
Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
ends.
• You can assign names to up to 32 FM stations and 16 AM
stations.
• All the station names will be erased if you press the Reset
button.
• If you want to change the name of a station, first display the
name of the station (following steps 1 and 2 above), then
change the letter(s) that you want by following steps 3 and 4.
NOTE
6
NOTE
5
Alphabet (upper case): A ~ Z
Alphabet (lower case): a ~ z
Numerals and symbols: 0~9 @ ” ‘ ` % & * + - = , . / \ < > [ ]
Special characters:
á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl
â ä ê ë î ï ô ö û ü ñ ç © Æ › fi
You can assign names to radio stations with the Station Preset
Memory. Up to 32 FM stations and 16 AM stations can be
assigned names.
Adjust the frequency to the station whose name you want to
enter.
Press the NAME.S button for at least two seconds.
"NAME SET" is displayed once the station name preset mode
is entered.
The cursor will blink in the position where letters are entered.
Press either the
4
or
¢
button to move the cursor to the
desired position.
The
4
button moves the cursor to the left, and the
¢
button to the right.
Each time the
38
button is pressed, the characters to be
entered change as listed below.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.
4
3
2
1
Station Name Preset (SNPS)
Switch the frequency step used in seeks. The factory defaults
are 50 kHz for FM and 9 kHz for AM.
While pressing buttons #1 and #5 at the same time, press the
reset button.
The frequency step settings will be changed to 200 kHz for FM
and 10 kHz for AM.
When you change the frequency step settings, all memory
contents will be erased.
Returning Frequency Step Settings to Original Values:
Repeat the operation as mentioned above.
NOTE
Frequency Step Setting
— 17 —
