Kenwood KMM-X10, Инструкция по эксплуатации

Страница: 4 / 30

4
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
GETTING STARTED
Set the initial settings
1 Press B SRC to enter STANDBY.
2 Press the volume knob to enter [FUNCTION] .
3
Turn the volume knob to make a selection (see the following table), then press
the knob.
4 Press and hold to exit.
To return to the previous setting item or hierarchy, press .
Default: XX
AUDIO CONTROL
SWITCH
PREOUT REAR / SUB-W : Selects whether rear speakers or a subwoofer are connected to the
line out terminals on the rear (through an external amplifier).
SP SELECT OFF / 5/4 / 6 × 9/6 / OEM : Selects according to the speaker size (5 inches or 4 inches,
6×9 inches or 6 inches) or OEM speakers for optimum performance.
TUNER SETTING
PRESET TYPE NORMAL : Memorizes one station for each preset button in each band (FM1/ FM2/
FM3/ MW/ SW1/ SW2). ; MIX : Memorizes one station for each preset button,
regardless of the selected band.
SYSTEM
KEY BEEP ON : Activates the keypress tone. ; OFF : Deactivates.
TDF ALARM ON : Activates the alarm if you forget to detach the faceplate when ACC is set to
OFF. ; OFF : Deactivates.
SOURCE SELECT
PANDORA SRC ON : Enables PANDORA in source selection. ; OFF : Disables. ( 9)
BUILT-IN AUX ON : Enables AUX in source selection. ; OFF : Disables. ( 8)
F/W UPDATE
UPDATE SYSTEM
F/W UP xx.xx YES : Starts upgrading the firmware. ; NO : Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
3
Cancel the demonstration
When you turn on the power (or after you reset the unit), the
display shows: “CANCEL DEMO” “PRESS” “VOLUME KNOB”
1 Press the volume knob.
[YES] is selected for the initial setup.
2
Press the volume knob again.
“DEMO OFF” appears.
Set the clock
1 Press the volume knob to enter
[FUNCTION]
.
2 Turn the volume knob to select [CLOCK] , then press the knob.
3
Turn the volume knob to select [CLOCK ADJUST] , then press the
knob.
4 Turn the volume knob to make the settings, then press the
knob.
Day Hour Minute
5
Turn the volume knob to select [CLOCK FORMAT] , then press
the knob.
6 Turn the volume knob to select [12H] or [24H] , then press the
knob.
7
Press and hold to exit.
To return to the previous setting item or hierarchy, press .
While in clock display screen...
Press and hold DISP SCRL to enter clock adjustment mode
directly.
Then, perform step 4 to set the clock.
1
2
EN_KMM_X30_MN_3.indd 4 EN_KMM_X30_MN_3.indd 4 11/10/2013 2:19:01 PM 11/10/2013 2:19:01 PM