KMC-17
2
●
KMC-17 (Type B)
The cap is not attached on the upper part of the case.
SCHEMATIC DIAGRAM
HOW TO DISTINGUISH BETWEEN DIFFERENT VERSIONS OF THE KMC-17
470p
PLUG
ø3.5 3P
PLUG
ø2.5 2P
PTT
MIC
(ECM)
SP
EARPHONE
JACK
ø2.5 3P
+
+
0
RED
SHIELD
BLACK
GREEN
0
4
3
2
1
4
R2
CN1
470p
CN2
NC
CN3
PLUG
ø3.5 3P
PLUG
ø2.5 2P
PTT
MIC
(ECM)
SP
EARPHONE
JACK
ø2.5 3P
+
+
0
3
2
1
1
2
3
4
R1
0
●
KMC-17 (Type A)
●
KMC-17 (Type B)
Document Copyrights
Copyright 2008 by Kenwood Corporation. All rights re-
served.
No part of this manual may be reproduced, translated,
distributed, or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or other-
wise, for any purpose without the prior written permission
of Kenwood.
Disclaimer
While every precaution has been taken in the preparation
of this manual, Kenwood assumes no responsibility for er-
rors or omissions. Neither is any liability assumed for dam-
ages resulting from the use of the information contained
herein. Kenwood reserves the right to make changes to any
products herein at any time for improvement purposes.
There are two versions of the KMC-17; one uses Type A and the other uses Type B. The components of each of these parts
are not compatible with each other.
An external part of Type A and Type B for the KMC-17 is different, allowing you to distinguish between them, as described
below.
●
KMC-17 (Type A)
The cap is attached on the upper part of the case.