14
installation
17. Make sure your plumbing is suitable for
use with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS
using the new water supply hose. OLD
HOSE SETS MUST NOT BE RE-USED.
The water pressure from the water mains
needs to be at a minimum of 0.04 MPa and
a maximum of 1.00MPa.
• Connect one end of the water supply
hose to your dishwasher, and then
connect the other end of the hose to
your water mains. Please ensure the
black rubber seal is in place.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
water mains
Y-Adaptor
(not included)
Connect
to another
appliance
if required.
safety water supply hose
16. Cut out a 600 mm wide slot from the plinth
so the unit door can fully open downwards.
The depth of the cut out should be
sufficient to allow the door to open fully and
will depend on the thickness of the panel
fitted to the door.
• Do not bend or kink your drain hose.
You may use a Y-adaptor (not included)
for an additional water feed for another
appliance, for example a washing
machine. This is only applicable to
the cold water mains. A Y-adaptor is
available from most DIY stores.
* All images are for reference only; please refer to your individual unit for actual item.
Kenwood Integrated Diswasher KID60S18 Manual.indd 14
07/12/2018 12:17