KGP-2A/2B
5
Transceiver Setting
When the KGP-2A/2B is connected to a transceiver, the
transceiver functions must be set. The transceiver FPU is
used to make this setting.
For a connection method, see Figure 1.
■
TK-
∗
80 Series Setting Method
1. Setting with KPG-49D (K and M markets FPU)
1) Select “Optional Features” from “Edit” on the menu bar
and change Com2 (Internal Port) from “[None]” to “[AUX
Hook/PTT]”.
2. Setting with KPG-60D (E markets FPU)
1) Select “Extended Function” from “Edit” on the menu
bar and change Com2 from “[None]” to “[AUX Hook/
PTT]”.
■
TK-
∗
60G Series Setting Method
Use the KPG-56D as the FPU.
1) Select “Key assignment” from “Edit” on the menu bar,
and set “Foot Switch” to ”[None]”.
REALIGNMENT
2) Select “Optional Features” from “Edit” on the menu
bar and change “ACC Hook/DTC” from “[ACC Hook]” to
“[DTC]”.
Note :
Applicable only for S/No. 302XXXXX or later.
KGP-2A/2B Setting
After programming the transceiver, you need to confi g-
ure the KGP-2A/2B. Using the FPU (KPG-73D), you can con-
fi gure the KGP-2A/2B .
Using a cross-wired serial cable (KGP-2A/2B side : D-sub
9- pin female) as shown in Figure 2, plug one connector into
the RS-232C (COM) port of your PC and the other end to
the ACC1 connector on the rear panel of the KGP-2A/2B.
■
KGP-2A/2B Setting Method
1) Create a data fi le using the FPU (KPG-73D).
2) After configuring the KGP-2A/2B to the Programming
Menu mode, upload the data fi le to the KGP-2A/2B.
• For detailed instructions, refer to the Help fi le included in
the FPU.
• To set the KGP-2A/2B in the Programming Menu mode,
refer to “Start the Programming Menu mode” on page 7.
IBM-PC
KPG-46
Transceiver
KGP-2A/2B
KPG-49D or KPG-60D : TK-
*
80
KPG-56D : TK-
*
60G
IBM-PC
KPG-73D : KGP-2A/2B
KGP-2A/2B
Transceiver
Cross-wired serial cable
(KGP-2A/2B side :
D-sub 9-pin female)
Fig. 1
Fig. 2
