Kenwood KDW243A, Инструкция по эксплуатации, Страница: 11 / 15

Never run the dishwasher without the filters in place.
If your dishwasher is left in an unheated place during the winter, ask a service technician to:
Cut off electrical power to the dishwasher.
Turn off the water supply and disconnect the water
inlet pipe from the water valve.
Drain water from the inlet and water valve. pipe
(Use a pan to catch the water.)
Reconnect the water inlet to the
water valve.
pipe
Remove the filter in the tub the bottom
and use a sponge to soak up water
in sump.
5
4
3
2
1
It is necessary to clean the spray arms regularly for hard water chemicals will clog the
spray arm jets and bearings. To remove the spray arm, screw off the nut to take out the
washer on top of the spray arm and remove the arm. Wash the arms in soapy and warm
water and use a soft brush to clean the jets. Replace them after rinsing them thoroughly.
Filter assembly
For best performance and results, the filter assembly must be cleaned.The filter efficiently removes food particles from the wash
water, allowing it to berecirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in
the filter after each wash cycle by rinsing the semicircular filter and cup under running water. To remove the filter assembly, pull
on the cuphandle in the upward direction. The entire filter assembly should be cleaned once a week.
To clean the coarse filter and the fine filter, use a cleaning brush. Then, reassemblethe filter parts as shown in the figures left and
reinsert the entire assembly in the dishwasher, positioning in its seat and pressing downward.
The dishwasher must never be used without the filters. Improper replacement of the filter may reduce the performance level of the
appliance and damage dishes and utensils.
When cleaning the filters, don't knock on them. Otherwise, the filters could be contorted and the performance of dishwasher
could be debased.
9
NOTE：
To install the filter system back, please do the following:
1. Gently insert the Fine filter back to the Filtering System.
2. Gently insert the Main Filter back to the Filtering System.
3. Gently insert the Coarse Filter back to the Filtering System, and screw back the Filter Cylinder securely.