operating instructions
GB-19
adjusting rinse aid reservoir
The rinse aid reservoir has six settings. Both the recommended setting and
the factory setting is “.” (Fig 2b on page 18)
If the dishes are not drying properly or are spotted, adjust the dial to the
next higher number until your dishes are spot-free.
adding of salt
If the water in your area is hard, depos-
its will form on your dishes and uten-
sils. As such, this appliance contains
a salt reservoir for you to reduce the
hardness of the water.
Please follow the steps below to pour
the salt into the salt reservoir and it
must be set to correspond to the water
hardness level in your area.
Remove the lower basket and un-
screw the reservoir cap. (Fig 1)
Fill the reservoir with approximately
500ml of water (first use only).
Place the funnel provided over the
salt reservoir. (Fig 2)
Place approximately 1.2kg of salt
depending on the brand used.
Clean any excess salt from around
the reservoir opening and then
screw the cap on again firmly.
Run the “rapid” wash programme
immediately (without any crockery
in the dishwasher) to remove any
traces of salt from the compart-
ment.
1.
2.
3.
.
5.
6.
OPEN
open
open
open
1
2
Содержание KDW1274W
Страница 2: ......
