English
|
37
Some functions of this unit may be disabled by
some settings made on this unit.
!
Cannot switch to Aux source.
▲
• AUX is not turned on.
☞
<Built-in Auxiliary input
Setting> (page 29)
• AUX cannot be used when the KCA-iP200 is
connected.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
▲
• <Subwoofer Output> (page 9) is not set to On.
• The Dual zone function is enabled.
☞
<Audio
Setup> (page 8)
!
• Cannot set up the high pass filter.
• Cannot set up the Fader.
▲
• The Dual zone function is enabled.
☞
<Audio
Setup> (page 8)
!
Cannot set up the subwoofer phase.
▲
Low pass filter is set to Through.
☞
<Audio Setup>
(page 8)
!
• Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear speakers.
▲
The Dual zone function is disabled.
☞
<Audio
Setup> (page 8)
!
No Audio control effect on AUX.
▲
The Dual zone function is enabled.
☞
<Audio
Setup> (page 8)
!
Cannot play audio files.
▲
<CD Read Setting> (page 29) is set to "2".
!
• Cannot File select.
• Cannot direct music serch.
▲
The Random play function is enabled.
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
?
The Touch Sensor Tone doesn’t sound.
✔
The preout jack is being used.
☞
The Touch Sensor Tone can’t be output from the
preout jack.
Tuner source
?
Radio reception is poor.
✔
The car antenna is not extended.
☞
Pull the antenna out all the way.
✔
The antenna control wire is not connected.
☞
Connect the wire correctly, referring to the
section on <Connecting Wires to Terminals>.
Disc source
?
The specified disc does not play, but another one
plays instead.
✔
The specified CD is quite dirty.
☞
Clean the CD.
✔
The disc is loaded in a different slot from that
specified.
☞
Eject the disc magazine and check the number
for the specified disc.
✔
The disc is severely scratched.
☞
Try another disc instead.
Audio file source
?
The sound skips when an Audio file is being
played.
✔
The media is scratched or dirty.
☞
Clean the media, referring to the CD cleaning of
the section on <Handling CDs> (page 5).
✔
The audio file is broken or not supported.
☞
Damaged and unsupported files are skipped.
✔
The recording condition is bad.
☞
Record the media again or use another media.
USB device source
?
The USB device is not detected.
✔
The USB connector is disconnected.
☞
Connect the connector of the USB device
properly.
?
The USB device does not play its audio files.
✔
The USB connector is disconnected.
☞
Connect the connector of the USB device
properly.
Troubleshooting Guide
B64-3638-00̲00̲M̲English.Indd 37
B64-3638-00̲00̲M̲English.Indd 37
07.1.5 10:27:14 AM
07.1.5 10:27:14 AM
