English
|
13
• "Preset": You can store an adjusted audio control
value by selecting "MEM". Refer to <Memory
mode> (page 17). Also, you can recall it by
selecting "RCL". Refer to <Memory Recall
mode> (page 17).
• X'Over (Crossover Network Setup)
You can manually set a crossover frequency for the
speakers.
• DTA (Digital Time Alignment)
Manually set the sound output timing of each
channel.
5
Adjust the Sound Field Control item
Push the Control knob towards [
4
] or
[
¢
].
Each time you push the knob, the setting
alternates between the settings shown in the
table below.
Sound Field Control Item
Range
Front High Pass Filter Center/
Rear High Pass Filter Center*
2
Through/30 — 100/120/150/
180/220/250 (Hz)
Front High Pass Filter Slope/
Rear High Pass Filter Slope*
2
/
Subwoofer Low Pass Filter Slope*
1
-12/-18/-24 dB/oct
Subwoofer Low Pass Filter Center*
1
30 — 100/120/150/180/220/
250 (Hz)/Through
Subwoofer Low Pass Filter Phase*
1
Reverse/ Normal
DTA Front/DTA Rear
*
2
DTA Subwoofer
*
1
0 — 610 (cm)
Position Setting
Front-L/ Front-R/ Front/ ALL
• When the "2 ZONE" of <Audio Setup> (page 12) is
"ON", the following setups are ignored.
- "XOver"
- "DTA"
- "POSI"
- "Preset"
• *
1
You can control this item when <Subwoofer
Output> (page 11) is set to "SW ON".
• *
1
You can control this item when Speaker Select
Subwoofer of <Sound Management system> (page
14) is set to any item other than "None".
• *
2
You can control this item when Speaker Select Rear
of <Sound Management system> (page 14) is set to
any item other than "None".
6
Exit Sound Field Control mode
Press the [6] ("RTN") button.
B64-3304-00̲01̲E̲English.indd 13
B64-3304-00̲01̲E̲English.indd 13
05.11.15 2:35:42 PM
05.11.15 2:35:42 PM
