14
KDC-MP5033U/MP532U
KDC-W534UA/UAY/UG/UGY/W5534U/UY
TEST MODE
●
FM/AM channel space switching
(KDC-MP5033U/MP532U only)
While power is OFF, press and hold [1] and [5] keys, and press
[SRC] key to power ON.
●
IC10 (X34-) Stereo adjustment (VCO adjustment)
While in test mode and all lights are lit (STANDBY), press and
hold [1] key and press [6] key for 3 seconds or longer.
“VCO ADJ” will be displayed for a second.
(Adjusted data will be written on E2PROM.)
●
Security
1) How to enter the forced POWER ON mode
While “– – – –” is being displayed, while simultaneously
pressing [Q] key and [4] key, press [RESET] button, With
this, it is possible to turn the power on for 30 minutes only.
2) How to register the security code on the “Car
Audio Passport” sheet after replacing E2PROM
(IC103) (For models of destination “E” or “M”)
1. Enter the test mode. (Refer to “How to enter the test mode”.)
2. In the test mode, press [Q] key to enter the MENU mode.
When “CODE_SET” is displayed, press [
] key for 1 sec-
ond or longer to enter the security registration mode.
3. Input the security code, using [FM] / [AM] / [
] / [
] keys.
[FM] key: number up / [AM] key: number down
[
] key: cursor to right / [
] key: cursor to left
4. After inputting the code, press [
] key for 3 seconds or
longer which causes “RE-ENTER” to be displayed. This is
for “confirming” the code. Use the method in the step 3 to
re-enter the code.
5. Then, press [
] key for 3 seconds or longer, which will
display “APPROVED”. This completes the security code reg-
istration.
6. Release the test mode. (Refer to “How to clear the test
mode”.)
∗
All clear cannot be used to clear the security code.
3) How to clear the programmable security code
(KDC-MP532U only)
1. While “– – – –” is being displayed, press [
] key for 3
seconds or longer while pressing the [AUTO] key. This
makes the “– – – –” display disappear.
2. Input “KCAR”, using the remote controller.
Press [5] key of the remote controller twice (Input for “K”)
and press [
] key.
Press [2] key of the remote controller 3 times (Input for “C”)
and press [
] key.
Press [2] key of the remote controller once (Input for “A”)
and press [
] key.
Press [7] key of the remote controller twice (Input for “R”)
and press [
] key.
3. The security is cleared and the unit enters STANDBY
source.
4. If wrong codes are input, “– – – –” will be displayed again.
