Kenwood KDC-M4524/G, Инструкция по эксплуатации

Страница: 27 / 33

— 27 —
What might seem to be a malfunction in your unit may
just be the result of slight misoperation or miswiring.
Before calling service, first check the following table
for possible problems.
General
?
The power does not turn ON. 01
✔ The fuse has blown.
☞ After checking for short circuits in the wires, replace the fuse with
one with the same rating.
?
There’s a source you can’t switch. 07
✔ There’s no media inserted.
☞ Set the media you want to listen to. If there’s no media in this
unit, you can't switch to each source.
✔ The Disc changer isn’t connected. 08
☞ Connect the Disc changer. If the Disc changer isn’t connected to
it's input terminal, You can't switch to an external disc source.
?
Even if Loudness is turned ON, high-pitched tone isn't compensated
for.
17
✔
Tuner source is selected.
☞
High-pitched tone isn't compensated for when in Tuner source.
?
No sound can be heard, or the volume is low.
✔ The fader or balance settings are set all the way to one side. 21
☞ Center the fader and balance settings.
✔ The values of Volume offset are low. 24
☞ Turn up the Volume offset, referring to the section on <Audio
control> (page10).
?
The sound quality is poor or distorted. 25
✔ One of the speaker wires is being pinched by a screw in the car.
☞ Check the speaker wiring.
✔ The speakers are not wired correctly. 27
☞ Reconnect the speaker wires so that each output terminal is
connected to a different speaker.
?
The Touch Sensor Tone doesn’t sound. 34
✔ The preout jack is being used.
☞ The Touch Sensor Tone can’t be output from the preout jack.
?
Even though Synchronize Clock is ON, the clock can’t be adjusted. 35
✔ The received RDS station isn’t sending time data.
☞ Receive another RDS station.
Tuner source
?
Radio reception is poor. 39
✔ The car antenna is not extended.
☞ Pull the antenna out all the way.
?
It isn't the set Traffic information sound volume.
43
✔
The set sound volume is less than the tuner sound volume.
☞
If the tuner sound volume is louder than the set sound volume,the
tuner sound volume is used.
Troubleshooting Guide