— 17 —
Inst allat ion Procedure
Angle adjustment sw itches
■
The angle adjustment sw itches on the both saides of the unit
are to be set according to the angle of installation of the CD
auto changer. Set both of the tw o sw itches to the same
position. If the sw itches are not set properly, sound skip or
other malfunction may occur.
Set the angle adjustment sw itches w ith a coin or other flat
object.
Change the sw itch step by step by detaching and reusing the
object at the end of each step.
Right side
Left side
Angle adjustm ent sw itches
90
90
0
45
90
0
45
Installation
angle
0°~5°
40°~50°
85°~90°
90
0
45
90
0
45
90
0
45
Angle
adjustment
sw itch
position
• It is not possible to install at an angle of
40°~ 50° if only
1
is used.
Inst allat ion
Installation of Display unit
■
• Installation w ithout using the trim m ount plate
7
Attach one velcro to the
slanted-line of the the display
units as show n above, and
attach the other velcro to the
parts w here you w ish to
attach the display units.
Then, put velcros together
and install the display units.
• Installation using the trim m ount plate
7
C D A U T O C H A N G E R C O N T R O L L E R
REP
RDM
3
1
¡
PWR
'
R D M
R E P
M H z
T R A C K
D I S C
8
/
T R A C K
FREQ
LEVEL
-
+
DISC
Display unit
Display unit
5
7
Pass the w ire from the display unit through the hole on the
trim mount plate and push fit the display unit into the trim
mount plate until it locks.
• Be sure not to place the unit on such place as w here it is
exposed to direct sunlight and temperature eventually rises.
It results in the deformation of the case.
• Depending on the installing location, the display unit may not
be able to receive the signals from the controller unit. Install
them after confirming that the signals can be received.
• Install the unit in such a w ay that it does not disturb driving.
2
CA U TION
