Kenwood KDC-4051UM, Инструкция по эксплуатации

Страница: 6 / 19

6
Getting started
Canceling the display
demonstration
The display demonstration is always turned
on unless you cancel it.
When you turn on the power (or after you
reset the unit), the display shows:
[CANCEL DEMO]
\
[PRESS]
\
[VOLUME KNOB]
1 Press the volume knob.
[YES] is selected as the initial setup.
2 Press the volume knob again to confirm.
[DEMO OFF] appears.
If no operation is done for about
15 seconds or if you turn the volume knob
to select
[NO] in step 2 , [DEMO MODE]
appears and the display demonstration
starts.
Setting the demonstration mode
1 Press the volume knob to enter
[FUNCTION] .
2 Turn the volume knob to select
[DEMO MODE] , then press to enter.
3 Turn the volume knob to select [ON] or
[OFF] .
If [ON] is selected, display demonstration
starts if no operation is done for about
20 seconds.
4 Hold to finish the procedure.
Adjusting the clock
1 Press the volume knob to enter
[FUNCTION] mode.
2 Turn the volume knob to select
[SETTINGS] , then press to enter.
3 Turn the volume knob to select [CLOCK] ,
then press to enter.
4 Turn the volume knob to select [CLOCK
ADJUST/ CLOCK ADJ] , then press to
enter.
Clock hour flashes on the display.
5 Turn the volume knob to adjust the
hour, then press to enter the minute
adjustment.
Clock minutes flashes on the display.
6 Turn the volume knob to adjust the
minute, then press to confirm.
Press
4
/
¢
to move between the
hour and minute adjustment.
7 Hold to finish the procedure.
Initial settings before operations
1 Press SRC to enter [STANDBY] mode.
2 Press the volume knob to enter
[FUNCTION] mode.
3 Turn the volume knob to select
[INITIAL SET] , then press to enter.
4 Turn the volume knob to make a
selection, then press to confirm.
See table on page 7 for selection.
5 Hold to finish the procedure.
Maintenance
Cleaning the unit: Wipe off the dirt on the
panel with a dry silicon or soft cloth. Failure
to observe this precaution may result in
damage to the monitor or unit.
Cleaning the connector: Wipe off dirt on
the connector of the unit and faceplate.
Use a cotton swab or cloth.
Handling discs
Do not touch the recording surface of the
disc.
Do not stick tape etc. on the disc, or use a
disc with tape stuck on it.
Do not use any accessories for the disc.
Clean from the center of the disc and
move outward.
Clean the disc with a dry silicon or soft
cloth. Do not use any solvents.
When removing discs from this unit, pull
them out horizontally.
Remove the rims from the center hole
and disc edge before inserting a disc.
EN02-19_KDC-U449[M]f.indd 6 EN02-19_KDC-U449[M]f.indd 6 9/13/10 5:37:29 PM 9/13/10 5:37:29 PM