Kenwood KCH-19, Руководство по обслуживанию

Страница: 6 / 18

1-6 (No.RA019<Rev.001>)
SECTION 3
DISASSEMBLY
3.1 Precautions for Disassembly
3.1.1 Removing the speaker hardware fixture (J2B-0023-
00) and holder (J1K-0019-00)
(1) Remove the speaker lead from the holder hook. <1>
(2) Remove the speaker connector from the display unit con-
nector (CN5). <2>
(3) When removing the speaker hardware fixture, insert a flat-
head screwdriver at the position shown in Figure 1-1 and
tilt it in the direction shown by the arrow. <3>
(4) To remove the holder, insert a flat-head screwdriver into
tab of the holder and tilt it in the direction shown by the ar-
row. <4>
Fig.1-1
Fig.1-2
3.2 Precautions for Reassembly
3.2.1 Installing the holder (J1K-0019-00) and speaker hard-
ware fixture (J2B-0023-00)
(1) Insert two tabs of the holder (J1K-0019-00) into the hollows
in the top of the panel. <1>
(2) Push the two tabs of the holder in on the opposite side of
those in step 1 above and fit them into the hollow in the bot-
tom of the panel. <2>
Note:
Push in the holder until it snaps in place.
(3) Install the speaker holder onto the panel. <3>
Note:
To improve water resistance, fit the panel into the groove
of the holder.
(4) Place the speaker into the speaker holder.
Note:
The speaker must not ride on the holder rib.
(5) Place the spacer on the speaker.
(6) Insert the hardware fixture (J2B-0023-00) into the hollow of
the panel as shown in Figure 2-3, then push two parts of
the hardware fixture and fit it into the hollow of the top of the
panel. (Fig. 2-3 <4>)
Note:
Push in the hardware fixture until it snaps in place.
(7) Insert the speaker connector into the display unit connector
(CN5).
(8) Place the speaker lead on the holder hook.
Fig.2-1
Fig.2-2
Fig.2-3
<2>
<1>
<3>
CN5
<4>
<1> <1>
<2>
Spacer
Speaker
Speaker holder
<3>
<4>