Kenwood FP770 series, Руководство пользователя

Страница: 4 / 8

2
key
processor
plate storage compartment
power unit
head release button
on/off speed control
pulse button
swivel head
bowl
removable bowl drive shaft
bowl lid seal
lid
feed tube
pusher
liquidiser
filler cap
lid
lid seal
top blade
removable drive shaft/bottom blade
jug
additional attachments
quad knife blade
dough tool
whipping tool
thick slicing plate
thin slicing plate
coarse shredding plate
fine shredding plate
rasping plate
fine chipper plate
plate carrier
centrifugal juicer attachment
spatula
to use your food processor
1 Fit the bowl to the power unit. Then fit the drive shaft to the bowl .
2 Fit an attachment over the drive shaft .
●
Always fit the bowl and attachment onto the processor before adding
ingredients.
3 Check the seal is fitted to the lid correctly (fit the grooved side of the seal into
the lid) then fit the lid .
4 Turn the swivel head clockwise and press down until it clicks shut to lock
securely . The processor will not operate if the head is not
located correctly.
5 Switch on and select a speed.
●
Use the pulse control for short burst. The pulse will operate for as long as the
button is held down.
●
The swivel head cannot be unlocked unless the speed control is
in the OFF position.
6 Reverse the above procedure to remove the lid, attachment and bowl. To
release the lid, hold one of the bowl handles whilst lifting the lid by the feed
tube
.
important
●
Your processor is not suitable for crushing or grinding coffee beans, or
converting granulated sugar to caster sugar.
●
When adding almond essence or flavouring to mixtures avoid contact with the
plastic as this may result in permanent marking.
before using your Kenwood appliance
●
Read these instructions carefully and retain for future reference.
●
Remove all packaging and any labels.
safety
●
The blades and plates are very sharp, handle with care. Always hold the
knife blade by the drive shaft, away from the cutting edge, both
when handling and cleaning.
●
The Quad knife blades are extremely sharp. Please refer to the
“using the attachments” section for instructions on safe handling.
●
Always remove the knife blade before pouring contents from the bowl.
●
Keep hands and utensils out of the processor bowl and liquidiser jug whilst
connected to the power supply.
●
Switch off and unplug:
● ●
before fitting or removing parts
● ● after use
● ● before cleaning
●
Note: Take care when handling the metal top of the drive shaft after prolonged
continuous use as it may become hot.
●
Never use your fingers to push food down the feed tube. Always use the
pusher/s supplied.
●
Do not put any part in the microwave.
●
Before removing the lid from the bowl or liquidiser from the power unit:-
● ● switch off;
● ● wait until the attachment/blades have completely stopped.
●
Allow all liquids to cool to room temperature before placing them in the
liquidiser.
●
This machine will be damaged and may cause injury if the
interlock mechanism is subjected to excessive force.
●
Never use an unauthorised attachment.
●
Never leave the machine on unattended.
●
Never use a damaged machine. Get it checked or repaired: see ‘service’.
●
Never let the power unit, cord or plug get wet.
●
Don’t let excess cord hang over the edge of a table or worktop or touch hot
surfaces.
●
Do not let infirm people use the appliance without supervision.
●
Do not let children use or play with the appliance.
●
Only use the appliance for its intended domestic use. Kenwood will not accept
any liability if the appliance is subject to improper use, or failure to comply with
these instructions.
before plugging in
●
Make sure your electricity supply is the same as the one shown on the
underside of your machine.
Important – UK only
●
The wires in the cord are coloured as follows:
Blue = Neutral, Brown = Live.
●
The appliance must be protected by a 13A approved (BS1362) fuse.
Note:
●
For non-rewireable plugs the fuse cover MUST be refitted when replacing the
fuse. If the fuse cover is lost then the plug must not be used until a replacement
can be obtained. The correct fuse cover is identified by colour and a
replacement may be obtained from your Kenwood Authorised Repairer (see
Service).
●
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An
electric shock hazard may arise if an unwanted non-rewireable plug is
inadvertently inserted into a 13A socket outlet.
●
This appliance complies with European Economic Community Directive
89/336/EEC.
before using for the first time
1 Remove all packaging including the plastic blade covers from the knife blade.
Take care the blades are very sharp. Blade covers can be used for
when blades are stored if required.
2 Wash the parts see ‘care & cleaning’.