English
|
9
Audio Setup
Setting the Sound system, such as Cross over
Network.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item
Display
Range
Front High Pass Filter
"HPF"
Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter
"HPR"
Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter
"LPF"
50/60/80/100/120/Through Hz
Subwoofer Phase
"PHAS"
Reverse (180°)/ Normal (0°)
Volume offset
"V-OFF"
–8 — ±0 (AUX: -8— +8)
Loudness
"LOUD"
OFF/ON
Dual Zone System
"2ZON"
OFF/ON
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones
during low volume. (Only the low tone is
compensated for when the tuner is selected
as a source.)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by <Dual Zone
System Setting> (page 26).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [VOL] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 8).
- The Audio Control has no effect on sub source.
• You can use the Dual Zone System with the internal
auxiliary input.
5
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Speaker Setting mode
Press the [VOL] knob.
3
Select the Speaker type
Turn the [VOL] knob.
Each time you turn the knob, the setting alternates
between the settings shown in the table below.
Speaker type
Display
OFF
"SP OFF"
For 5 & 4 in. speaker
"SP 5/4"
For 6 & 6x9 in. speaker
"SP 6*9/6"
For the OEM speaker
"SP OEM"
4
Exit Speaker Setting mode
Press the [VOL] knob.
Subwoofer Output
Turning the Subwoofer output ON or OFF.
Push the Control knob toward down for at least
2 seconds.
Each time you push the knob, Subwoofer output
switches ON and OFF.
When it is ON, "SW ON" is displayed.
B64-3826-00̲00̲English.Indd 9
B64-3826-00̲00̲English.Indd 9
07.4.24 11:32:07 AM
07.4.24 11:32:07 AM
