30
|
English
Some functions of this unit may be disabled by
some settings made on this unit.
!
Cannot switch to Aux source.
▲
AUX is not turned on.
☞
<Built-in Auxiliary input Setting> (page 22)
!
• Cannot set up the subwoofer.
• No output from the subwoofer.
▲
• Preout is not set to subwoofer.
☞
<Switching preout> (page 22)
• <Subwoofer Output> (page 10) is not set to ON.
• The Dual zone function is enabled.
☞
<Audio Setup> (page 8)
!
Cannot set up the subwoofer phase.
▲
• Preout is not set to subwoofer.
☞
<Switching preout> (page 22)
• <Subwoofer Output> (page 10) is not set to ON.
• The Dual zone function is enabled.
☞
<Audio Setup> (page 8)
• Low pass filter is set to Through.
☞
<Audio Setup> (page 8)
!
Cannot set up the low pass filter.
▲
• Preout is not set to subwoofer.
☞
<Switching preout> (page 22)
• The Dual zone function is enabled.
☞
<Audio Setup> (page 8)
!
Cannot set up the high pass filter.
▲
The Dual zone function is enabled.
☞
<Audio Setup> (page 8)
!
• Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear speakers.
▲
The Dual zone function is disabled.
☞
<Audio Setup> (page 8)
!
• No Audio control effect on AUX.
• Cannot set up the Preout.
▲
The Dual zone function is enabled.
☞
<Audio Setup> (page 8)
!
Cannot play audio files.
▲
<CD Read Setting> (page 22) is set to "2".
!
Cannot Folder select.
▲
The Scan play or Random play function is enabled.
!
Cannot set up WOW.
▲
The Dual zone function is disabled.
☞
<Audio Setup> (page 8)
!
Cannot set up SRS 3D.
▲
The tuner source is in use.
!
No Audio control effect on the rear speakers.
▲
WOW item on <SRS WOW Select> (page 9) and SRS
WOW item on <SRS WOW Control> (page 9) have no
effect on the rear speakers.
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
?
The Touch Sensor Tone doesn’t sound.
✔
The preout jack is being used.
☞
The Touch Sensor Tone can’t be output from the
preout jack.
Tuner source
?
Radio reception is poor.
✔
The car antenna is not extended.
☞
Pull the antenna out all the way.
✔
The antenna control wire is not connected.
☞
Connect the wire correctly, referring to the
section on <Connecting Wires to Terminals>.
Disc source
?
The specified disc does not play, but another one
plays instead.
✔
The specified CD is quite dirty.
☞
Clean the CD.
✔
The disc is loaded in a different slot from that
specified.
☞
Eject the disc magazine and check the number
for the specified disc.
✔
The disc is severely scratched.
☞
Try another disc instead.
Audio file source
?
The sound skips when an Audio file is being
played.
✔
The media is scratched or dirty.
☞
Clean the media, referring to the CD cleaning of
the section on <Handling CDs> (page 5).
✔
The recording condition is bad.
☞
Record the media again or use another media.
Troubleshooting Guide
B64-3609-00̲English̲r5.indd Sec1:30
B64-3609-00̲English̲r5.indd Sec1:30
06.12.7 2:06:32 PM
06.12.7 2:06:32 PM