Kenwood DPX-MP3110, Инструкция по эксплуатации

Страница: 23 / 28

English
|
23
Troubleshooting Guide
Some functions of this unit may be disabled by
some settings made on this unit.
!
• Cannot set up the subwoofer.
• Cannot set up the High Pass Filter.
• Cannot set up the Fader.
• No Audio control effect on AUX.
▲
• Preout is not set to subwoofer.
☞
“SWPRE” of
<Menu System> (page 14)
• “Subwoofer output” of <Baisc Operatiom> (page 4)
is not set to On.
• The Dual zone function is enabled.
☞
<Audio
Setup> (page 8)
!
• Cannot set up the subwoofer phase.
▲
The Low Pass Filter is set to Through.
☞
<Audio
Setup> (page 8)
!
• Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear speakers.
▲
The Dual zone function is disabled.
☞
<Audio
Setup> (page 8)
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
Tuner source
?
Radio reception is poor.
✔
The car antenna is not extended.
☞
Pull the antenna out all the way.
Disc source
?
The specified disc does not play, but another one
plays instead.
✔
The specified CD is quite dirty.
☞
Clean the CD.
✔
The disc is loaded in a different slot from that
specified.
☞
Eject the disc magazine and check the number
for the specified disc.
✔
The disc is severely scratched.
☞
Try another disc instead.
Audio file source
?
The sound skips when an Audio file is being
played.
✔
The media is scratched or dirty.
☞
Clean the media, referring to the CD cleaning of
the section on <Handling CDs> (page 3).
✔
The recording condition is bad.
☞
Record the media again or use another media.
?
Noise is heard when carrying out Folder Search.
✔
Noise may be produced if folders without audio files
exist continuously in the playing media.
☞
Do not make folders without audio files.
Cassette tape source
?
The sound quality is poor or distorted.
✔
The tape head is dirty.
☞
Clean the tape head.
?
The DPSS, Tape Advance and Music Repeat don’t
operate correctly.
✔
The space between the songs on the tape can’t be
recognized because it’s too short.
☞
Have at least 5 seconds between songs.
✔
The space between songs can’t be recognized
because there’s too much noise between songs.
☞
Reduce the noise between songs.
?
The blank skip doesn’t work.
✔
Because noise is too loud, the non-recorded part
can’t be recognized.
☞
Reduce the noise between songs.
?
Blank Skip functions at places that are recorded.
✔
Because the recording level is low, it’s recognized as
not recorded.
☞
Turn Blank Skip OFF.
B64-4186-00̲00̲English.indd 23 B64-4186-00̲00̲English.indd 23 08.2.5 1:09:32 PM 08.2.5 1:09:32 PM