4
|
DNX SERIES/ DDX SERIES
B
C
PRK SW
B
C
A
A
Connection
If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.
Antenna Cord
FM/AM
antenna input
For the sake of safety, be sure to connect the parking sensor.
Parking sensor wire (Light Green)
Connect to the vehicle's parking brake
detection switch harness.
Battery wire (Yellow)
Ground wire (Black)
-
(To car chassis)
Ignition wire (Red)
Steering remote control wire (Light Blue/Yellow)
To steering remote
If no connections are made, do not let the cable come out from the tab.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
Mute control wire (Brown)
Depending on what antenna you are using,
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
Motor antenna control wire (Blue)
When using the optional power amplifier,
connect to its power control terminal.
Power control wire (Blue/White)
To car light control switch
Dimmer control wire (Orange/White)
Reveres sensor wire (Purple/White)
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
Ignition key
switch
ACC
Car fuse box
(Main fuse)
Battery
Car fuse box
To connect the Kenwood navigation system,
consult your navigation manual.
To use the steering wheel remote control feature, you need to
an exclusive remote adapter (not supplied) matches your car is
required. When this terminal is not in use, leave its cap on.
⁄
⁄
⁄
⁄
¤
B54-4766-10̲01̲DNX5̲M-X̲En.indd 4
B54-4766-10̲01̲DNX5̲M-X̲En.indd 4
09.12.25 11:20:58 AM
09.12.25 11:20:58 AM