Kenwood CR-M30DAB, Руководство по эксплуатации

Страница: 29 / 100

9
4.5 Operation with USB mains adapter
You can also operate the radio with the supplied mains adapter. The ”Alarms ” function is available in
this operating mode.
4.6 DAB + / FM telescopic antenna
1. Carefully unlock the antenna on the right rear part of the casing.
2. Turn the antenna upwards and pull out all the elements completely.
3. Align the antenna for the best reception.
5. Operating the radio
5.1 Switching On / Off (standby)
Hold and press the < /FUNC> button until the radio is switched on. To set the device in the Standby
mode, hold and press until the time appears on the Display. To switch the device back on again from the
Standby mode, briefly p ess the button.
In order to switch it off completely from the Standby mode, press and hold the
< /FUNC>
button. The
"POWER OFF" appears briefly in the Display and the device switches o f.
5.2 Navigate in the menus
Keep the <MENU/INFO> button pressed to call up the source-related menu .
By pressing the <Tune +> or <Tune -> button, you can navigate in the menu. You can also use the vol-
ume control for browsing. Confirm the menu selection with the
<ENTER/SCAN> button.
If you briefly
press the
<MENU/INFO>
button in a menu, you will jump back to the previous menu level.
5.3 Adjusting the volume
You can adjust the volume by turning the volume control. The volume setting is graphically displayed in
the Display.
5.4 Additional information
By repeatedly pressing the <MENU/INFO> button, depending on the source and station, additional in-
formation can be displayed:
• Description
• Name of the station, the current program, content, topics, etc.
• Genre
• Signal level and signal error
• Bit rate
• Channel information
• Today's date and current time
5.5 Setting the menu language
1. S witch on the radio and call up the menu with <MENU/INFO> button .
2. Using the <TUNE+/-> button or the volume control, select the "Language" menu and confir .
3. Select the desired language with the <Tune+/-> button and confirm with <ENTER/SCAN> .