Kenwood C-V751, Инструкция по эксплуатации

Страница: 17 / 64

17
Setup of the Graphical Remote Control (GRC) unit
5
Repeat steps
2
through
4
until you have taught GRC all the
commands you want it to know. If you need more lines,
touch or to access more lines.
4
Assign a name to the function.
2
Press the “Modify” icon.
3
Press the or icon to select one of
“Empty 1 to 8”.
1
Repeat steps
1
and
2
in “To program STOP as a new
control item”.
^
5
Aim the device’s remote at GRC and press and hold the
button on the device’s remote that corresponds to the
command you want GRC to learn.
10 cm
÷
Touch to access to lowercase characters. Touch it again to
access special characters (such as @, !, &, etc.). Touch it a third time
to return to uppercase characters.
÷
Touch or to move back and forth between the characters.
÷
Touch BS (Backspace) to clear the last caracter you entered. Touch
ALL DEL to delete all the characters in the line.
÷
The name can be composed using up to 8 characters.
÷
This may take a few seconds; do not move GRC or the device’s remote
until GRC displays the Function change menu again.
÷
Be sure to use the device’s original remote. GRC will not learn
commmands from other universal remotes.
6
Repeat steps
2
through
5
until you have taught GRC all the
commands you want it to know. If you need more lines,
touch or to access more lines.
÷
The additionally programmed function is registered in the area.
Programming an additional function which is not dis-
played in the screen