Kenwood 6202 - KAC Amplifier, Инструкция по эксплуатации

Страница: 4 / 40

4
English
Controls / Indicator
(W)
30
40
20
10
1
4
2 3
3
1 FILTER switch
This switch allows to apply high-pass or low-pass
filtering to the speaker outputs.
• HPF (High-Pass Filter) position:
The filter outputs the band of higher frequencies
than the frequency set with the FILTER
FREQUENCY control.
• OFF position:
The entire bandwidth is output without filtering.
• LPF (Low-Pass Filter) position:
The filter outputs the band of lower frequencies
than the frequency set with the FILTER
FREQUENCY control.
2
FILTER FREQUENCY control
Sets the cutoff frequency when the FILTER switch
is set to LPF or HPF.
3
INPUT SENSITIVITY control
Set this control according to the pre-output level
of the center unit connected with this unit, or
to the maximum power output of the genuine-
accessory car stereo.
Use the diagram on the right as a guide.
NOTE
For the pre-output level or the maximum power
output, refer to the <Specifications> in the
instruction manual of the center unit.
4 OPERATION switch
This switch is used to select the operation mode
of the amplifier.
• STEREO position:
The amplifier can be used as a stereo amplifier.
• MONO (Lch) position:
Amplifies the signal input from the left side
only. Set to this position and make bridged
connections to use as a high-power monaural
amplifier. (The input right signal is not output.)
B64-3041-00-00̲KE̲English.indd 4 B64-3041-00-00̲KE̲English.indd 4 04.12.27 1:25:03 PM 04.12.27 1:25:03 PM