Page 4
For technical questions, please call 1-888-866-5797.
Item 64274
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Towing Vehicle Installation
Note:
Use the BLUE Splice Connectors to make the connections in steps 1-3.
1. Connect the BROWN wire of the Trunk Harness (4)
to the towing vehicle’s Running Lights wire.
2. Connect the YELLOW wire of the Trunk Harness
to the vehicle’s Left Stop & Turn light.
3. Connect the GREEN wire of the Trunk Harness
to the vehicle’s Right Stop & Turn light.
4. Attach the WHITE GROUND wire to
the towing vehicle’s frame.
Trailer Installation
NOTE: INSTALL THE TRAILER LIGHTS ONLY AFTER THE TRAILER IS FULLY ASSEMBLED.
1. Mount the Tail Light (1b), marked “LH” (with the
License Window on bottom), on the left rear of the
trailer with its side marker to the outside of the trailer.
Then, mount the License Plate
Bracket (2) underneath it.
2. Mount the Tail Light (1a), marked “RH” (without the
License Window), on the right rear of the trailer
with its side marker to the outside of the trailer.
3. Use the included Metal Frame Clips to mount
each half of the Y-Harness (3) down each
side of the trailer. Run one YELLOW wire
and one BROWN wire down the left side
and one GREEN wire and one BROWN
wire down the right side of the trailer.
4. Connect the YELLOW and BROWN wires to the Left
Tail Light (1b) with the included Wire Nut Connectors.
5. Connect the GREEN and BROWN wires to the Right
Tail Light (1a) with the included Wire Nut Connectors.
6. Attach the WHITE GROUND wire to
the trailer tongue or frame.
Note:
These Trailer Lights depend on
a metal, grounded trailer frame.
