Kentec Electronics Sigma A-CP, Инструкция по установке и эксплуатации

Страница: 67 / 107

Installing the Battery-Fuse
To install the 6.3 Amp battery-fuse:
1
Confirm that 115 VAC or 230 VAC is turned-off at the source.
2
Install the replacement fuse in the upper-half of the fuse-housing.
3
Connect the upper-half to the lower-half of the fuse-housing.
4
Secure the fascia-door to the cabinet of the Sigma A-CP Fire Control Panel with the retaining-screw.
5
Re-connect the red-lead of the recharging circuit to the positive terminal of the standby-batteries.
6
Close the fascia-door of the Sigma A-CP Fire Control Panel.
7
Connect NAC Power and Power inserts from the fascia terminal strip of the Sigma A-CP Fire Control Panel.
8
Turn on 115 VAC or 230 VAC at the power source.
9
Test the fire control panel by operating it to determine that it functions.
Transformer Fuse
The following procedures describe methods for removing and installing the 6.3 Amp transformer fuse
of the Sigma A-CP Fire Control Panel.
Removing the Transformer Fuse
To remove the 6.3 Amp transformer fuse:
1
Turn off 115 VAC or 230 VAC at the power source.
2
Disconnect the red-lead of the recharging circuit from the positive terminal of the standby-battery.
3
Remove NAC Power and Power inserts from the fascia terminal strip of the Sigma A-CP Fire Control Panel.
4
Remove the retaining-screw securing the fascia to the cabinet of the Sigma A-CP Fire Control Panel.
5
Open the fascia-door of the Sigma A-CP Fire Control Panel.
6
Remove the transformer fuse from the fuse-housing.
www.acornfiresecurity.com
www.acornfiresecurity.com