4
Power Selection
• To select the LOW power option, press the
setting adjustment button (-), only the small
blue ‘low power’ light will light up on the
digital display.
• To select the HIGH power option press the
setting adjustment button (+). Both blue
lights will light up to indicate ‘high power’.
LOW Power
HIGH Power
KPE216-408
1000W
2000W
Thermostat Function
• Press the temperature select button , the
current thermostat setting will flash then
it will return to display the current room
temperature.
• Press the setting adjustment buttons, (+) or
(-) to add 0.5°C or reduce 0.5°C between
the range of 5°C to 36°C.
• Once the desired temperature is set wait 5
seconds, the heater will exit the thermostat
function and return to normal operation.
The current room temperature will be
displayed. To view the set temperature at
any time, press the button.
Note:
The heater’s digital thermostat reads the
temperature immediately around the heater.
Actual average room temperature may vary to
the reading showing on the digital display of
the heater.
Timer Function
• To set the number of hours the heater
will run before automatically switching off
press the timer select button then press the
setting adjustment buttons (+) or (-) to add
0.5 hours or reduce 0.5 hours between the
range of 0-18 hours).
• Once the desired time is set wait 5 seconds,
the heater will exit the timer function and
return to normal operation. To view the time
set at any time, press the
button.
Memory Function
• When the heater is switched to STANDBY the
last thermostat temperature will be retained
in the heater’s memory the next time the
heater is switched ON, unless the heater
switched OFF using the power switch.
Note: The timer setting is not retained.
Remote Control
• The remote control duplicates all the
controls that are on the control panel.
Please refer to the above instructions for
operation.
SAFETY FEATURES
Over-Heat Protection
• This heater is protected with an over-heat
protection cut-out facility that switches it
off automatically if it over-heats.
• Overheating can be caused by obstruction
to the air intakes on the back of the heater
or the grill on the front.
• If this occurs please disconnect the heater
from the power socket and allow it to cool
for 30 minutes. Remove any obstruction
and turn the heater back on.
• The heater should operate normally.
Should the problem persist contact your
nearest service centre.
Safety Cut-Out Switch
• The heater is fitted with a safety cut-out
switch to switch the heater off if it is
knocked over.
• If the heater is knocked over and the
cut-out switch activates turn the heater off
at the power outlet and take EXTREME
care when standing the heater upright as it
will still be hot.
• Inspect the heater for damage especially to
the heating elements and supply cord.
• If any damage is visible do not operate the
heater.
