KENT KPE216-161, Руководство пользователя

Страница: 5 / 8

5
OPERATING INSTRUCTIONS
24 Hour Timer Function
- 11 Fin Model only
• Switch the heater on and set the thermostat
to the desired temperature.
• Set the red switch to “ ” to activate the
timer.
• The timer face consists of a moveable
numbered band with moveable red pins
and a fixed centre plate. When the
moveable red pins are slid towards the
centre plate the timer is OFF and when slid
towards the outer numbered band the timer
is ON. Each red pin corresponds to 15
minutes operation.
• Rotate the timer dial until the current time is
opposite the pointer.
• Slide the red pins corresponding to the
required ON time towards the outer
numbered band.
• The red pins corresponding to the required
OFF time are slid towards the inner band.
Example: Suppose
it is now at 11:00PM.
Rotate the timer until
“23” is opposite to
the pointer (i.e.
Position A). For
operation between
8:00AM and 3:00PM, slide the red switch to
“ ”, all the red pins between “8” and 15”
(i.e. Area B) are slid towards the outer band
and those between “15” and “8” are slid
towards the inner band.
• Manual over-ride: activating the bypass
function on the timer by setting the red
switch to “I” will enable the heater to be
switched “ON” (I) and “OFF”(0) without
disrupting the timer programme.
• Turn the heater off fully by setting the red
switch to “0”.
SAFETY FEATURES
Over-Heat Protection
• This heater is protected with an over-heat
protection cut-out facility that switches it off
automatically if it over-heats.
• Overheating can be caused by obstruction
to the air intakes on the back of the heater
or the grill on the front.
• If this occurs please disconnect the heater
from the power socket and allow it to cool
for 30 minutes. Remove any obstruction
and turn the heater back on.
• The heater should operate normally.
Should the problem persist contact your
nearest service centre.
Safety Cut-Out Switch
• The heater is fitted with a safety cut-out
switch to switch the heater off if it is
knocked over.
• If the heater is knocked over and the
cut-out switch activates turn the heater off
at the power outlet and take EXTREME
care when standing the heater upright as it
will still be hot.
• Inspect the heater for damage especially to
the heating elements and supply cord.
• If any damage is visible do not operate the
heater.