Safety Cut-Out Switch
• The heater is fitted with a safety cut-out
switch to switch the heater off if it is
knocked over.
• If the heater is knocked over and the
cut-out switch activates turn the heater off
at the power outlet and take EXTREME
care when standing the heater upright as it
will still be hot.
• Inspect the heater for damage especially to
the heating elements and supply cord.
• If any damage is visible do not operate the
heater.
CLEANING AND CARE
• IMPORTANT: Turn off the heater. Switch
off the power switch and disconnect the
heater from the power socket. Wait for
the heater to be completely cool before
cleaning.
• Vacuum clean air vents and grilles to
remove dust from these areas.
• To remove dust on external surfaces, wipe
the heater with a damp (not wet) lint-
free cloth rinsed in hot soapy water only.
• Do not use any harsh detergent or abrasive
cleaners.
• Do not spray with liquids or submerge in
liquids or water.
• Do not attempt to clean the interior of the
heater.
• Do not attempt to open the heater casing
at any time.
STORAGE
• Store the heater carefully in a dust-free
area during the off season. It is ideal
to store the heater in the carton it was
supplied in. Neatly wind the cord of the
heater to prevent damage to the cord.
• Unwind the power cord and plug your
heater into a power socket (observing the
instructions regarding positioning). Ensure
the voltage on the specification plate is the
same as in your home and the power cord
is lying safely on the ground.
• Indicator light is on when heater is plugged
in and power is switched on.
• Switch the heater ON by selecting:
a. power setting I – 750W or
b. power setting II – 1500W
Thermostat Function
• Set the desired room temperature by turning
the thermostat dial clockwise to the desired
position. You may adjust the temperature
during use. To turn down the thermostat turn
the dial anti-clockwise.
• To find the ideal thermostat setting for you,
first set the knob to the maximum position.
As soon as the temperature is comfortable,
turn the thermostat down slowly, until the
heater turns off. The heater will keep the
surrounding air at this set temperature
by switching on and off at intervals. The
indicator light lights up when the heater is
on.
• To switch the heater off fully, turn the power
switch to “0” and the thermostat to “•”. The
indicator light will only turn off when the
power is switched off at the wall.
SAFETY FEATURES
Over-Heat Protection
• This heater is protected with an over-heat
protection cut-out facility that switches it off
automatically if it over-heats.
• Overheating can be caused by obstruction
to the air intakes on the back of the heater
or the grill on the front.
• If this occurs please disconnect the heater
from the power socket and allow it to cool
for 30 minutes. Remove any obstruction
and turn the heater back on.
• The heater should operate normally.
Should the problem persist contact your
nearest service centre.
3
