Kensington HB-NTQ, Инструкция по эксплуатации

Страница: 9 / 16

9
0800 422 274 NZ
Instructions
Attaching and detaching the controllers
The two controllers for the electric blanket are detachable so that you can take
them off before washing the blanket. If you want to leave your blanket on the bed
all year round as a comfortable underblanket, we recommend you remove and
store the controllers during the summer months.
Whenever you need to attach or detach the controllers, ensure that their power
switches are in the OFF position and not connected to the power supply.
• To connect a controller, thread the detachable plug of the controller through
the hole in the skirt and plug it fully into the socket. Ensure that the locking
clip engages with the small plastic pin on the plug.
• To detach a controller, push out the locking clip to release the socket pin and
withdraw the connector plug by pulling it away from the socket.
Using the electric blanket
This electric blanket is operated with two detachable controllers. Each controller
features dual zone heating, for the body and feet, which you can adjust separately
in 9 heat settings. Heat setting 1 is the lowest, setting 9 the highest. An in-built
timer enables automatic operation of the blanket heating at the start and finish
times of your choice (AUTO). The BOOST button is available in both MANUAL
and AUTO modes.
Programming the controllers
• Ensure the controller switch is in the OFF position.
• Insert the power plug into a power outlet and
switch the outlet on. On the display, [ 12:00 ] and
[ AM ] will illuminate.
Setting the clock
• With the controller switch still set to OFF, press
the TIMER button. The hour display will flash and
CLOCK SET will illuminate. Use the [ + ] or [ - ]
buttons to select the correct hour.
• Press the TIMER button again and the minute
display will flash. Use the [ + ] or [ - ] buttons to
select the correct minutes.
• Press the TIMER button again to set the time and
CLOCK SET will disappear from the display.
NOTE: Make sure you have the correct AM or PM
showing in the display.