Tube
Suction cup
Pump housing
Back cover
Filter/
Front cover
Regulator
Impeller cover
Rotor/Impeller
51112COPBL ASSEMBLY INSTRUCTIONS
PUMP SAFETY & TROUBLESHOOTING
To clean the pump
Unpl
ug the pump f
r
om the e
lectrical
outlet. U
se a small soft brush or
place it
If the pump fails to run:
• This pump has an overheating protection feature that will turn off
the pump when it becomes too hot while not covered with water.
It may take a few minutes for the pump to cool down once it is
submerged in water again. Note: the pump may cycle on and off
as it cools and heats if not covered with water.
• Pump may be air locked, unplug and plug pump in several times to
clear trapped air.
• Check circuit breaker, or try a different outlet.
• Check tubing for kinks and obstructions.
• Clean out any algae buildup.
• Remove the front cover & impeller cover to access the impeller area.
Turn the rotor to ensure it is not broken or jammed.
With low flow rate, the pump will spew or “burp”:
• Check the water level to make sure the pump is completely
submerged, water should always be above the min fill line (not
all water features include min fill line).
un
d
er a
w
ater str
eam to
r
em
o
v
e
d
ebris.
To keep water clean
P
eriodi
cally chan
g
e
w
ater
to pre
v
en
t algae bui
l
d
up.
