Thank you for purchasing this Kennedy product. We produce value-built products for value
conscious users. We welcome any comments or suggestions you may have. Just call or write
the address below. We hope you will continue to find Kennedy the most complete source for
your tool storage needs.
VERSA-BENCH
®
ASSEMBLY INSTRUCTIONS
STYLE NUMBERS—
BEFORE ASSEMBLY OF YOUR VERSA-BENCH
®
Check carefully to ensure that all parts listed on the reverse side are included. If any are missing, please call
800-413-8665 and ask for the Sales Dept. Do not discard packing material until assembly is complete.
TOOLS REQUIRED
Flat tip screwdriver
7/16” Open end wrench or socket wrench
9/16” Open end wrench or socket wrench
KMC Holdings LLC dba Kennedy Manufacturing Company
1260 Industrial Drive • Van Wert, OH 45891
Phone 800-413-8665 • Fax 419-238-5644 • www.kennedymfg.com
Part No. 527034, Rev. 8/07
4804
4804
4806
4806
6006
6006
6012E
6012E
VB Towing parts
X
S
T
U
Y
Y
V
R
Q
W
Versa-Bench
®
Towing Package Assembly Instructions
Note: To be used in conjuction with Versa-Bench Assembly Instructions
ASSEMBLY SUPPLY LIST
QTY KEY PART DESCRIPTION
1
(Q)
Bottom pan front reinforcement with cross
plate (has 3 sets of bolt hole piercings)
2
(R)
Swivel Casters
2
(S)
Rigid Casters
16
(T)
3/8” x 1-1/2” Hex Head Bolts
16
(U)
3/8” Lock Nuts
1
(V)
Tongue Plate
4
(W)
3/8-16 x 1” Bolts
1
(X)
Rear bottom pan reinforcement
(has 2 sets of bolt hole piercings)
1
(Y)
Towing tongue, pin, (2) cotter keys
With Versa-Bench laying on back, proceed as follows:
1. Position the front reinforcement with cross plate (Q) under front of bench as shown, aligning the bolt holes of
both the front reinforcement and bench. Fasten the swivel casters (R) and the front reinforcement to the bench
with (8) 3/8” x 1-1/2” hex head bolts (T) and (8) 3/8” lock nuts (U). Bolt heads should be inside the bench, lock
nuts below the caster plate.
2. Bolt tongue plate (V) to the front reinforcement cross plate with (4) 3/8-16 x 1” bolts.
3. Align towing tongue (Y) tongue plate (V), insert pin and hair pin (Y).
4. Fasten the rear bottom pan reinforcement (X) and rigid casters (S) to the bench with remaining 3/8” bolts
and lock nuts.
5. Set the bench upright and proceed with instruction number (7) of the Versa-Bench Assembly Instruction on
previous page.
6012S
6012 S
