Installation and User’s Guide
CellSet MC/BT2
Document part number 65272R1
Kennedy Technology Group, Inc.
614 Ridgeway, Rose Hill, Kansas 67133 USA
voice 316.776.1111
fax 316.776.9035
email:[email protected]
www.cellset.com
Thank you for purchasing our product!
We hope that your new
CellSet
gives you many hours of convenient, clear, and comfortable operation.
This product is designed to connect to a variety of intercoms and Bluetooth headset adapters. It must be used
in conjunction with a KTG Intercom Harness, and a KTG Cell Phone Harness (each sold and packaged
separately).
OPERATION
Besides providing an audio interface between the bike intercom and a Bluetooth headset adapter, this
CellSet
provides a timed charging function for the adapter (provided you purchased a combination audio/power cell
phone harness).
CellSet
charges the adapter for a period of three (3) hours
after
you turn your bike “OFF”. After 3 hours,
CellSet
stops charging the adapter and goes to sleep: While asleep, it draws only a few micro amperes of
current.
POWER HARNESS INSTALLATION
Locate the power harness, (part number 85833) and connector kit. Included in the kit are:
2 ea.
Red, #10 insulated ring terminals
1 ea.
un-insulated 1/4” ring terminal
3 ea.
Red, tap and run terminal. (22 to 18 gauge wire)
1 ea.
Inline fuse kit
Locate
fused
, unswitched, (always “on”) and switched (on/off with ignition) power points on your
motorcycle.
Never connect directly to the battery without an inline fuse.
Make the following connections:
RED - Unswitched power
GREEN - Switched power
BLACK - Chassis ground
HARNESS INSTALLATION
Refer to the instructions sheets provided with the Intercom Harness, and Cell Phone Harness. When you
complete those installations refer back to this sheet.
