50230 Assembly Supply List
Qty
Key
Part Description
3
(A)
Hanger Brackets
1
(B)
99852 Tool Holder Set
50260 Assembly Supply List
Qty
Key
Part Description
3
(A)
Hanger Brackets
1
(B)
99853 Tool Holder Set
2
(C)
50202 Swing-out Panel
4
(D)
Rail Support Bracket
494019 Bolt Pack Contains:
12
(E)
1/4-20 Panel Nut Retainer
12
1/4-20 x 1/2 Bolts
12
Washers
Model 50260 Swing-out Panel Assembly
NOTE: ASSEMBLY REQUIRED BEFORE MOUNTING CABINET TO HANGER BRACKET.
1. Snap two of the 1/4-20 panel nut retainer into square holes of swing panel mounting rail.
2. Align swing panel mounting rail to inside wall.
3. Bolt swing panel mounting rail from outside cabinet wall with 1/4-20 bolts and washers.
4. Snap the 1/4-20 panel nut retainer into the square holes of rail support brackets.
5. Bolt rail support brackets to inside rail, then bolt rail support brackets to inside wall.
Note: Two rail support brackets will be mounted flange-up and two mounted flange-down.
Hanger Bracket Assembly
1. Determine location for attachment of hanger brackets. Use level to align bracket and mark mounting holes.
Note: Bracket must be in square alignment.
2. Drill pilot holes.
3. Attach hanger brackets.
4. Hang wall-mount cabinet to the three hanger brackets.
Part No. 527138, Rev. 7/03
page 2 of 2
Kennedy Manufacturing Company • 520 E. Sycamore St. • Van Wert, Ohio 45891
Phone: 800-413-8665 • Fax: 419/238-5644 • www.kennedymfg.com
B
E
D
C
B
A
HOLES IN
PANEL NOT
SHOWN
ONE HALF
OF BODY
SHOWN