Side burner
□
Loosen side burner in side shelf. (B ). To loosen, unscrew and remove two front screws and washers
holding sideburner in place. (A). Note: Do not loosen electrode screw.
□
Remove the 2 pre-installed screws from the valve stem and set them aside. (C)
□
Insert valve stem through hole in fascia. (D).
Install previously removed 2 screws .Note:
Leave a
1/8-inch gap below the screw heads for bezel attachment. (E).
□
Attach bezel to fascia and valve face with the installed screws. Make sure the black mark is facing
up.(F). Tighten the 2 screws.(G)
□
Place sideburner tube over the valve, making sure that valve is inside sideburner tube. (H)
□
Push control knob onto sideburner valve stem. (I)
□
Reattach sideburner to sideburner shelf with the 2 previously removed screws. Replace sideburner
grate. (J)
□
Connect both igniter wires to the igniter module on the inside of the right fascia. To connect, push
igniter wire tips onto pins in igniter module.(K)
□
Unscrew igniter cap from control panel. Insert (1) AA battery (provided in blister pack) into battery
slot with positive end (+) facing outward. Screw igniter cap back onto panel. (L)
A
B
C
D E
F
G H
I
J K
L
6
Содержание PG-40406SOL-1
