Kenmore KM5K, Инструкция по использованию и уходу

Страница: 21 / 26

Troubleshooting Your Water Optimizer
17
Issue #5:
My Water Optimizer’s Hot Mode isn’t hot.
Please note, this appliance is heating system is preset to a temperature range of
172.4°F - 194°F (78°C -90°C). This temperature is not adjustable.
Solution 1: Flip
T
Hot Mode Power Switch up to “ON” / “I” position at rear of the
appliance.
Issue #6: My Water Optimizer’s Cold Mode isn’t cold.
Please note, this appliance is cooling system is preset to a temperature range of
39.2°F - 42.8°F (4°C - 6°C). This temperature is not adjustable.
Solution 1:
Flip
S
Cold Mode Power Switch
up to “ON” / “I” position at rear of the
appliance.
Solution 2:
N
Cold Water Tank water level may have been drained and exhausted by
above average use, and requires sufficient time to replenish.
Solution 3:
Compressor may have failed or lost the R-134A refrigerant. If compressor
is running continuously and/or feels extremely hot to touch, power off
S
Cold Mode Power Switch , and contact support at 1-844-374-6576 , or support@
drinkpod.com
.
Issue #7:
My Water Optimizer is beeping or lights are flashing.
When your Water Optimizer’s beeping and/or the status lights are blinking
(sometimes all 3 or just one red light), it means that the
Leak Detection Sensor
has
detected water and shut down the system as a pre-caution against flooding. This is why
we recommend laying a towel down over the sensor when setting up the unit or changing
filters, so as not to get water onto the interior base.
To clear/reset: Unplug the
U
110v Power Cord . Open the
M
Stainless Steel Cabinet Door to filter area to inside. Trace the white wire (with
red stripe) running down to the base, on left side behind the filters, to the
R
Leak Detection Sensor
. Remove the screw on the mounting bracket. Lift out the
Leak Detection Sensor (looks like a circuit board). Dry it thoroughly, and then dry out
the entire cavity. Re-plug the unit to power to reset the program. Check for any leaking
water. Reinstall the
Leak Detection Sensor , mounting bracket, and screw. Good to go!