19
THE WATER HEATER SHOULD BE LOCATED IN AN
AREA WHERE THE GENERAL PUBLIC DOES NOT HAVE
ACCESS. IF A SUITABLE AREA IS NOT AVAILABLE, A
COVER SHOULD BE INSTALLED OVER THE THERMOSTAT
TO PREVENT TAMPERING. Suitable covers are available
through the Sears Service Center.
Never allow small children to use a hot water tap, or to draw their
own bath water. Never leave a child or handicapped person
unattended in a bathtub or shower.
It is recommended that lower water temperatures be used to
avoid the risk of scalding. It is further recommended, in all cases,
that the water temperature be set for the lowest temperature
which satisfi es your hot water needs. This will also provide the
most energy effi cient operation of the water heater.
NOTE: A water temperature range of 120°F-140°F (49°C-60°C)
is recommended by most dishwasher manufacturers.
The thermostat of this water heater has been factory set at its
lowest position (OFF). It is adjustable and must be reset to the
desired temperature setting. The faceplate of the thermostat is
marked with approximate temperature settings. The preferred
starting point is approximately 120°F (49°C). Align the knob with
the desired water temperature as shown in Figure 21. There is a
hot water scald potential if the thermostat is set too high. Some
states have a requirement for a lower setting.
Turn the water temperature dial clockwise (
) to increase
the temperature, or counterclockwise (
) to decrease the
temperature.
Should overheating occur or the gas supply fail to shut off, turn
off the manual gas control valve to the appliance.
THERMOSTAT DIAL
Temperature Regulation
Due to the nature of the typical gas water heater, the water
temperature in certain situations may vary up to 30F° (16.7 C°)
higher or lower at the point of use such as, bathtubs, showers,
sink, etc.
HOTTER WATER CAN SCALD: Water heaters are intended to
produce hot water. Water heated to a temperature which will
satisfy space heating, clothes washing, dish washing, and other
sanitizing needs can scald and permanently injure you upon
contact. Some people are more likely to be permanently injured
by hot water than others. These include the elderly, children,
the infi rm, or physically/mentally handicapped. If anyone using
hot water in your home fi ts into one of these groups or if there is
a local code or state law requiring a certain temperature water
at the hot water tap, then you must take special precautions. In
addition to using the lowest possible temperature setting that
satisfi es your hot water needs, a means such as a mixing valve
should be used at the hot water taps used by these people or
at the water heater. Mixing valves are available at plumbing
supply or hardware stores. Follow manufacturer’s instructions
for installation of the valves. Before changing the factory setting
on the thermostat, see Figures 21 and 22.
FIGURE 21.
FIGURE 22.
160°F (71°C)
About 1/2 second
150°F (66°C)
About 1-1/2 seconds
140°F (60°C)
Less than 5 seconds
130°F (54°C)
About 30 seconds
120°F (49°C)
More than 5 minutes
VAC = approx. 80°F (27°C)
- - - - - - - - - - - - - - - -
Temperature
Settings
Time to Produce 2nd & 3rd
Degree Burns on Adult Skin
Содержание HydroSense 153.33443
Страница 3: ...3 SAFETY PRECAUTIONS ...
Страница 18: ...18 OPERATING INSTRUCTIONS ...
Страница 27: ...27 FIGURE 28 GAS VALVE BACKPLATE GAS VALVE NIPPLE ...
Страница 31: ...31 NOTES ...