6
Door Removal Instructions
Door Handle Mounting Instructions
1. Remove handle from carton and any
other protective packaging.
2. Position refrigerator handle end caps
over upper and lower pre-installed
shoulder bolts (A) that are fastened
into door, ensuring the holes for the set
screws are facing towards the outside
of door if it is a single unit installation,
or towards the freezer door if install
-
ing the matching freezer.
3. While holding handle firmly against
door, fasten upper and lower Allen set
screws (B) with supplied Allen wrench.
4. Repeat steps 2 and 3 to install freezer
handle (if installing the matching
freezer). Ensure the holes for the set
screws are facing towards the refrig
-
erator door.
NOTE
All set screws should be tightened and
sub-flush of handle end cap (Allen set
screw should be seated just below the
surface of the end cap). The end caps
should be drawn tight to appliance door
with no gaps.
A
B
Single Unit Installation
Ensure Handle Set Screws
are Facing Each Other
With Doors Closed.
Matching Refrigerator and Freezer
Door Handle Installation
Kick Plate Removal
To remove the kick plate, use a Phillips head
screwdriver and remove the 2 screws holding
the kick plate to the cabinet. Then pull the
kick plate away from the unit.
Remove Screws
