Kenmore 795.71012.010, Руководство по обслуживанию

Страница: 9 / 46

- 9 -
3-6 DEFROST CONTROL ASSEMBLY
Defrost control assembly consists of defrost sensor and
FUSE–M.
The defrost sensor works to defrost automatically. It is
attached to the metal side of the evaporator and senses its
temperature. At 72°C, it turns the defrost heater off.
FUSE–M is a safety device for preventing over-heating of
the heater when defrosting.
1. Pull out the grille assembly. (Figure 11)
2. Separate the connector with the defrost control
assembly and replace the defrost control assembly after
cutting the tie wrap. (Figure 12)
Figure 11 Figure 12
GRILLE ASSEMBLY
DEFROST-CONTROL
ASSEMBLY
4. Make sure the bulbs are cool to the touch.
Turn bulbs counterclockwise to remove.
5. Assemble in reverse order by snapping the Lamp Cover
in, engaging the rear tabs followed by the front tabs.
(Max. 60 W-2EA)
3-5 FAN AND FAN MOTOR
1. Remove the freezer shelf. (If your refrigerator has an
icemaker, remove the icemaker first)
2. Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
3. Remove the grille by removing one screw and pulling
the grille forward.
4. Remove the fan motor assembly by loosening 2 screws
and disassembling the shroud.
5. Pull out the fan and separate the fan motor and bracket.
1. Unplug refrigerator power cord form outlet.
2. Using a flat instrument, gently pry the lamp cover loose
in the front as shown. Rotate downward to remove the
rear tabs.
3. Make sure the bulb is cool to the touch. Turn the bulb
counterclockwise to remove.
4. Replace with a new 60-watt appliance bulb.
5. Insert tabs on back of cover into slots in freezer ceiling.
Push cover up to snap front into place.
3-7-2 Freezer Compartment Lamp
Figure 13
Figure 14
1. Remove the upper and lower
caps by using a flat
screwdriver, and remove 2
screws. (Figure 16)
2. Disconnect the lead wire on
the bottom position.
3-8 MULTI DUCT
Figure 16
Figure 10
BRACKET
MOTOR
FAN MOTOR
FAN
GRILLE
3-7 LAMP
3-7-1 Refrigerator Compartment Lamp
1. Unplug Refrigerator, or disconnect power at the circuit
breaker.
2. If necessary, remove top shelf or shelves.
3. Using a flat instrument, gently pry the cover loose in the
front as shown. Rotate downward to remove rear tabs.