18
Setting Oven Controls
Setting the Clock
The
key is used to set the clock. The clock may be set for 12
or 24 hour time of day operation. The clock has been preset at
the factory for the 12 hour operation. When the range is
plugged in, or when the power supply to the range has been
interrupted, the time in the display will flash.
Press
. The display will stop flashing.
Example: Setting the clock for 1:30:
1.
Press .
CLO will appear in the display.
2. Press 1 3 0 using the numeric keypad to set time of day.
3. Press
.
4. Time of day will now appear in the display.
Setting Minute Timer
The Timer ON/OFF controls the timer that can be used during
any of the other oven control functions, except self clean and
Sabbath. It does not start or stop any cooking function.
To set Timer for 5 minutes:
1.
Press Timer ON/OFF. When dashes appear in the display
press the number 5 key and press
. The time will begin
to count down.
2. When timer runs out, End and TIMER show in display. The
clock will beep three times every 7 seconds until Timer ON/
OFF is pressed. Press Timer ON/OFF to cancel the timer at
any time.
To Set Add 1 Minute
The Add 1 Minute key is used to set the Add 1 Minute feature.
When the key is pressed, 1 minute is added to the timer if
already active. If the timer is not active and Add 1 Minute is
pressed, the timer will start and will begin counting down from 1
minute. Each press of the key will add 1 minute to the timer.
Changing Between 12 or 24 Hour Time of Day
1.
Press and hold
for about 6 seconds until 12 Hr day or
24 Hr day appears in the display.
2. Press Self Clean to switch between the 12 and 24 hour time
of day displays. The display will show either 12 Hr of 24 Hr.
3. Press
to accept the change or press
to reject.
4. Reset the correct time as prescribed in
.
Note: if the 24 hour time of day was selected, the clock will now
display time from 0:00 through 23:59 hours.
Setting Continuous Bake or 12 Hour Energy Saving
The Timer ON/OFF and Self Clean keys control the continuous
bake or 12 hour energy saving features. The oven control has a
factory preset 12 hour energy saving feature that turns off the
oven if left on for more than 11 hours and 59 minutes. The oven
can be programed to override this for continuous baking.
To set the Continuous Bake or 12 Hour Energy feature:
1.
Press and hold Timer ON/OFF for about 6 seconds. The
display will show either 12 Hr OFF or Stay On and the
control will beep once.
2. Press Self Clean to switch between the 12 hour energy
saving and continuous bake features.
Note: 12 Hr OFF indicates the control is set for the 12 hour
energy saving mode. Stay On indicates the control is set for the
continuous baking.
3. Press
to accept your selection and the display will
return to show the time of day.
Figure 20: Setting timer for 5 minutes
Figure 21: Display shows energy saving or continuous cooking
