35
Oven Controls
When Self Clean is Finished
1.
The Cln message will turn off, and Hot will appear in
display window.
2. Once the oven has cooled down (about 1 hour) and Hot is
no longer displayed the oven door may be opened.
3. The oven broil element may appear to have cooled once
the oven door is unlocked. The element may still be hot and
burns may occur if the element is touched before it has
cooled.
4. When the oven interior has completely cooled, wipe away
any residue or powdered ash with a damp cloth or paper
towel.
Use caution when opening the oven door after
self cleaning. The oven may still be very hot and can cause
burns. To avoid possible burns, stand to the side of the oven
when opening the oven door to allow hot air or steam to escape.
Important:
The kitchen area should be well ventilated. Use an open window,
ventilation fan, or exhaust hood during the first self clean cycle
to help eliminate the normal odors associated with the initial self
clean cycle.
When the clean time finishes, the oven door will remain locked
until the oven has cooled sufficiently. In addition to the clean
time that was programmed, allow about 1 additional hour for
the oven to cool before opening the oven door.
Important note: The Self Clean function will not operate when
the oven lockout is active.
Setting Delay Start Self Clean
To start a delay Self Clean with default clean time of 3 hours
and a start time of 9:00 o’clock:
1.
Be sure the clock is set with the correct time of day, the oven
is empty, and all of the oven racks are removed. Be sure
oven door is completely closed.
2. Press Upper Oven or Lower Oven key.
3. Press Self Clean.
4. Press
Delay Start
.
5. Using number keys, enter
9 0 0
for time to start.
6. Press
.
If it becomes necessary to stop Self Clean when active:
1.
Press .
2. If Self Clean has heated the oven to a high temperature,
allow enough time for the oven to cool and the HOT
message to disappear. When this message turns off, the
oven may be opened.
Important:
•
When Self Clean is active, you may check the amount of
clean time remaining by pressing the Self Clean key once.
•
If your clock is set with the (default) 12 hr display mode, the
Delay Start for a Self Clean can only be programmed to
start up to 11 hours and 59 minutes after the time showing in
the display (be sure to set the clock to current time before
programming a delay start). To set a Delay Start Self Clean
to begin 12 or more hours (maximum is 23 hours and 59
minutes) after the time of setting, be sure to first set the
control in the 24 Hr display mode.
•
If Self Clean was active and then interrupted by a power
failure or cancelled before the oven was thoroughly
cleaned, it may be necessary to run another Self Clean
cycle.
•
If the oven temperature was high enough when Self Clean
was interrupted, the oven control may not allow another
Self Clean cycle to be set for up to 4 hours.
