Kenmore 665.7796 series, Инструкция по использованию и уходу

Страница: 18 / 48

18
Canceling A Cycle
1. Press CANCEL/DRAIN. The Cancel/Drain light will light up.
2. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher drain completely. The light turns off after
2 minutes. The door must be closed for the dishwasher to drain.
Changing A Cycle After Dishwasher Is Started
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser
before restarting your new cycle.
3. Press CANCEL/DRAIN twice to reset the control.
4. Select new cycles and options.
5. Firmly close the door and press START/RESUME.
Adding A Dish After Dishwasher Is Started
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check whether the detergent dispenser cover is still closed. If it is open, the wash cycle has already started and
adding a dish is not recommended.
3. If detergent has not yet been used (detergent dispenser cover is closed), you may add a dish.
4. Firmly close the door and press START/RESUME.
Status Indicator Lights
Front Panel Lights - The left light indicates the dishwasher is in the wash cycle.
The middle light indicates the dishwasher is in the dry cycle. The right-hand,
green Clean light indicates the cycle is complete and ready to unload. If the
Clean light is blinking, see “Troubleshooting” section. The Start light remains on
until the cycle is completed.
A. Wash cycle
B. Dry cycle C. Clean light
D. Start
A B C
D