20
Surfaces
Aluminum (Trim Pieces) & Vinyl
Painted and Plastic Control Knobs,
Body Parts, and Decorative Trim
Stainless Steel, Chrome Control Panel,
Decorative Trim
Porcelain Enamel Broiler Pan and
Insert, Door Liner, Body Parts, Warmer
Drawer
(some models)
Oven Racks
Oven door
Ceramic Cooktop
How to Clean
Use hot, soapy water and a cloth. Dry with a clean cloth.
For general cleaning
, use hot, soapy water and a cloth.
For more difficult soils and
built-up grease
, apply a liquid detergent directly onto the soil. Leave on soil for 30
to 60 minutes. Rinse with a damp cloth and dry.
DO NOT
use abrasive cleaners
on any of these materials; they can scratch. To remove control knobs, turn to the
OFF position; grasp firmly and pull straight off the shaft. To replace knobs after
cleaning, line up the flat sides of both the knob and the shaft; then push the knob
into place.
Before cleaning the control panel,
turn all controls to OFF and remove the control
knobs. To remove, pull each knob straight off the shaft. Clean using hot, soapy
water and a dishcloth. Rinse with a clean water using a dishcloth. Be sure to
squeeze excess water from the cloth before wiping the panel; especially when
wiping around the controls. Excess water in or around the controls may cause
damage to the appliance.To replace knobs after cleaning, line up the flat sides of
both the knob and the shaft; then push the knob into place.
Clean
stainless steel
with hot, soapy water and a dishcloth. Rinse with clean
water and a cloth.
Do not use cleaners with high concentrations of chlorides
or chlorines.
Do not use harsh scrubbing cleaners. Only use kitchen cleaners
that are especially made for cleaning stainless steel. Always be sure to rinse the
cleaners from the surface as bluish stains may occur during heating that cannot
be removed.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a
1:1 solution of clear water and ammonia.
If necessary
, cover difficult spots with an
ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a
damp cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe dry with
a clean cloth. Remove all cleaners or the porcelain may become damaged during
future heating.
DO NOT
use spray oven cleaners on the cooktop.
Remove the oven racks before starting a Self-Clean cycle for cleaning. After
removal, clean by using a mild, abrasive cleaner following manufacturer's instructions.
Rinse with clean water and dry.
If the racks are cleaned in the Self-Clean cycle, their color will turn slightly blue and
the finish will be dull. After the Self-Clean cycle is complete, and the oven has
cooled, rub the sides of the racks with wax paper or a cloth containing a small
amount salad oil (this will make the racks glide easier into the rack positions).
Use soap & water to thoroughly clean the top, sides and front of the oven door.
Rinse well. You may use a glass cleaner on the outside glass of the oven door.
DO NOT
immerse the door in water.
DO NOT spray or allow water or the glass
cleaner to enter the door vents.
DO NOT use oven cleaners, cleaning powders
or any harsh abrasive cleaning materials on the outside of the oven door.
DO NOT
clean the oven door gasket. The oven door gasket is made of a woven
material, on Self-Cleaning models, which is essential for a good seal. Care should
be taken not to rub, damage or remove this gasket.
See Cooktop Cleaning and Maintenance in the
General Care & Cleaning
section.
General Care & Cleaning
Cleaning Table
