Kenmore 415.1664901, Инструкция по использованию и уходу

Страница: 8 / 36

8 • 464224011
Rotisserie Burner
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Turn controls and gas source or tank OFF when not
in use.
WARNING
Match Light
Hole
Match shown next to burner
tube (under heat tent)
Figure A
Figure B
Figure D
Main Burner Ignitor Lighting
s
Do not lean over grill while lighting.
1. Turn OFF all Gas Burner Control Valves.
2. Turn ON gas source or tank.
3. Open lid during Lighting.
4. Push and turn main burner control knob to and hold
in. You will hear a clicking sound as the burner is being
ignited. Ignition should occur within 5 seconds, but
continue to hold the knob in for a full 10 seconds to
maintain ignition.
5. Once burner has ignited, turn knob to desired setting.
6. If Ignition does NOT occur in 5 seconds, turn the burner
control to OFF , wait 5 minutes , and
repeat the lighting procedure.
7. Repeat steps 4 through 6 for the remaining main burners.
for gas to clear away
Searing Sideburner Ignitor Lighting
s
Do not lean over grill while lighting.
1. Open lid during lighting. Turn on gas at LP cylinder.
2. Push and turn control knob to and hold in. You will
hear a clicking sound as the burner is being ignited.
Ignition should occur within 5 seconds, but continue to
hold the knob in for a full 10 seconds to maintain ignition.
3. Once burner has ignited, turn knob to desired setting.
4. If ignition does
NOT occur in 5 seconds, turn the burner
control OFF . Wait 5 minutes , and
repeat the lighting procedure.
for gas to clear away
Rotisserie Burner Ignitor Lighting
s
Do not lean over grill while lighting.
1. Open lid during lighting. Turn on gas at LP cylinder.
2. Push and turn control knob to and hold in. You will
hear a clicking sound as the burner is being ignited.
Ignition should occur within 5 seconds, but continue to
hold the knob in for a full 10 seconds to maintain ignition.
3. Once burner has ignited, turn knob to desired setting.
4. If ignition does
NOT occur in 5 seconds, turn the burner
control OFF . Wait 5 minutes , and
repeat the lighting procedure.
for gas to clear away
Match-Lighting
s
Do not lean over grill while lighting.
s
Open lid. Turn on gas at LP cylinder.
s
Light Burners one at time.
Match Lighting the Main Burners
1. Place match into match holder (hanging from right cart
side).
2. Strike the match and position lit match through match
light hole on RH side of cart. Shown Figure A .
3. Position lit match next to burner. Shown Figure B .
4. Push in and turn far right control knob to position.
Be sure burner lights and stays lit.
5. If ignition does NOT occur in 5 seconds, turn the burner
control knob OFF , wait 5 minutes ,
and repeat the lighting procedure.
6. Light other burners in sequence from right to left by
pushing knob in and turning to position.
for gas to clear away
Match lighting the Rotisserie Burner - Figure C
1. Place match in match holder. Strike the Match. Position lit
match close to the front center of the rotisserie burner.
2. Push in and turn rotisserie burner control knob to . Be
sure burner lights and stays lit.
3. If ignition does NOT occur in 5 seconds, turn the burner
control knob OFF , wait 5 minutes ,
and repeat the lighting procedure.
for gas to clear away
Match lighting the Searing Sideburner - Figure D
1. Place match in matchholder. Strike the Match. Position lit
match close to the Searing
burner.
2. Push in and turn Searing burner
knob to position. Be sure
burner lights and stays lit.
3. If ignition does NOT occur in 5
seconds, turn the burner control
knob
OFF , wait 5 minutes
, and repeat
the lighting procedure.
for
gas to clear away
Figure C
Match holder