20 • 463731403
CAUTION
FACT:
Sometimes spiders and other small insects climb into
the burner tubes attached to the burners. The spiders spin
webs, build nests and lay eggs. The webs or nests can be
very small, but they are very strong and can block the flow of
gas. Clean burners prior to use after storing, at the beginning
of grilling season or after a period of one month not being
used.
NATURAL HAZARD • SPIDERS
Typical spider webs inside burner.
Spider guards are on the air intakes in an effort to reduce this
problem, but it will not eliminate it! An obstruction can result
in a "flashback" (a fire in the burner tubes). The grill may still
light, but the obstruction does not allow full gas flow to the
burners.
Smell gas.
Burner(s) will not light.
A small yellow flame from burner (should be blue).
Fire coming from around or behind control knob.
Follow the “
” instructions.
Clean burners often. Use a 12” pipe cleaner to clean out the
burner tubes. You may also force a stream of water from a
hose nozzle through burner tubes to clean them.
IF YOU EXPERIENCE THE FOLLOWING:
1.
2.
3.
4.
STOP!
Immediately turn off gas at LP tank!
SOLUTION:
Wait for grill to cool.
Cleaning The Burner Assembly
4. Remove screw holding collector box. Note which hole on
collector box used for attaching to burner. Remove collector
box and clean ceramic portion of electrode with rubbing
alcohol and cloth.
5. Under control panel, disengage burner springs from burner
tubes.
.
6. To remove burner, slide backwards, lift up and out of grill.
7. Clean outside of burner with soap and water. Lay burner
upside down on flat surface. Force a stream of water through
tubes. Make sure water comes out of all burner holes. Open
clogged holes with a thin wire.
and
examine holes. Due to normal wear and corrosion, some
holes may become enlarged. If any large cracks or holes are
found replace burner.
8. If grill is to be stored, coat burner lightly with cooking oil.
Wrap in protective cover to keep insects out. If not storing grill
after cleaning, hold burner at an angle and insert into grill
bottom.
9. After cleaning, insert wire and electrode into hole in grill
bottom. Reattach collector box to burner with screw.
10. Place end of spring into hole on underside of burner tube, as
before, to secure burner. See figure A.
11. Reattach round connector of ignitor wire to ignitor.
12. Reposition VapoRISER bar wire, VapoRISER bars and
cooking grate. Reattach clean can to grease clip.
13. Before cooking again on grill, follow
.
Do not remove springs from valves
Shake out excess water
Be sure
to use correct hole.
VERY IMPORTANT: Burner tube must engage valve opening
as shown.
"Burner Flame Check"
Cleaning The Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1.
2. Remove cooking grate, VapoRISER bars and VapoRiSER bar
wire.
3. Remove grease can from beneath grill. Beneath control
panel, disconnect ignitor wire from ignitor.
Turn gas off at control knobs and LP tank.
Screw
Burner
Collector
Box
Valve
Burner
Tube
Spring
Electrode
Ignitor
Wire
Ignitor
s
Do not
use charcoal
with this grill.
A