Kenmore 25850, Руководство пользователя

Страница: 11 / 24

• The dehumidifier power cord
is unplugged
• The fuse is blown or circuit
breaker is tripped.
• Water bucket is full
• Bucket is not installed.
• Room humidity level is less
than selected humidity setting.
• Auto Restart.
• Did not allow enough time to
remove the moisture.
• Airflow is restricted.
• The humidity control may not
be set low humidity.
• Doors and windows may not
be closed tightly.
• Clothes dryer may be blowing
moisture-laden air into the room.
• Room temperature is too low.
• Area to be dehumidified is too large.
• Doors and windows are open.
• Dehumidifier has been
recently turned on. Room
temperature is below 42 °F
(6°C) .
• Drain hose connection may be
loose.
• Water bucket is out of
position.
• Display window on control
panel reads "ON".
• Room Humidity is higher than
Humidity setting.
• Make sure the dehumidifier plug is pushed
completely into the outlet.
• Check the house fuse or circuit breaker box and
replace the fuse or reset the breaker.
• The dehumidifier automatically turns off when
this occurs. Empty the bucket.
• Make sure the bucket is in the right place.
• Press the
humidity control button to
lower the humidity setting below room level.
• Unit has 3 minute delay once power is restarted.
• When first installed, allow at least 3 or 4 days to
achieve and maintain the desired dryness.
• Make sure there are no curtains, blinds or
furniture blocking the front or back of the
dehumidifier.
• Press the Humidity Control button to
lower the humidity.
• Check that all doors, windows and other
openings are securely closed.
• Install the dehumidifier away from the dryer.
The dryer should be vented to the outside.
• The dehumidifier may not operate efficiently if the
room temperature is below 42 ˚F(6˚C).
• Refer to the Selection Guide on page 6.
• Close all doors and windows to the outside.
• This is normal. Frost will usually disappear within
60 minutes.
• Ensure that the room temperature is at the
minimum of 42 ˚F(6˚C).
• Check the hose if one is attached.
• Ensure bucket is properly positioned.
• Press to raise humidity setting to 35% or above.
See page 7.
• Press the humidity control button to change
the humidity higher setting than room level,
highest humidity is 70%.
Problem Possible Causes What To Do
Dehumidifier
does not start
Dehumidifier does
not dry the air as
it should
Dehumidifier seems
to run too much
Frost appears on
the coils
Water on floor
Dehumidifier
operates
continuously
The dehumidifier may be operating abnormally when:
TROUBLESHOOTING
- 11 -
E
N
G
L
IS
H
ENGLISH