10
First Steps
7. Remove three screws on bottom hinge
and anti-tip bracket (if equipped)
with ⅜” socket wrench.
8. Remove toe grille support and screws
(if equipped).
9. Install bottom hinge and anti-tip
bracket (if equipped) on opposite
side with the three screws removed
from step 7.
10. Unscrew bottom hinge pin using
adjustable wrench. Move hinge pin to
other hole in hinge and tighten with
adjustable wrench.
D oor S top
S crew
D oor
S top
W as her
H inge
Pin
B ottom
H inge
T oe
Grille
S crews
the thickest part between the doors
on the handle side approximately 3
inches from the outside edge. This will
ensure proper spacing.
11. Install toe grille support and screws
on opposite side (if equipped).
12. Reverse door handles (see Handle
Installation section).
13. Move freezer and refrigerator door
stops to opposite side. Before starting
screws, use an awl to puncture the
foam.
14. Position refrigerator door onto bottom
hinge pin and screw center hinge pin
through center hinge into top of door.
Close refrigerator door to help align
hinge hole.
15. Tighten center hinge pin with
adjustable wrench.
16. Remove cabinet and hinge hole plugs
and move to opposite side.
17. Lower freezer door onto center hinge
pin.
18. Close freezer door. Lift up on handle
side of door and grasp the thinnest
part of the top hinge cover (which
was removed in Step 2) and insert
19. Tighten the top hinge screws and
check door gasket for open seal
condition (gap between gasket and
cabinet flange).
L ook f or open areas b etween the
gas k et and the cab inet f lange.
Gaske
t sh ould se al against the
cab inet all the way around including top
and b ottom