Kenmore 253.22052, Инструкция по использованию и уходу

Страница: 6 / 14

6
CAUTION
To allow door to close and seal
properly, DO NOT let food packages
extend past the front of shelves.
First Steps
Door Removal
If door must be removed:
1. Gently lay the unit on its back, on
a rug or blanket.
2. Remove 2 base screws and base panel.
3. Remove wire from clips on bottom
of cabinet if required.
4. Unplug connector, if required, by hold-
ing the cabinet connector in place and
pulling the door connector out.
5. Remove bottom hinge screws.
6. Remove plastic top hinge cover.
7. Remove screws from top hinge.
8. Remove top hinge from cabinet.
9. Remove door and bottom hinge
Repositioning the Mid-Level Basket
(some models):
1. To remove the support-hanging
basket, press upward on underside
of front of support to release from
shelf rod.
2. Rotate front under the shelf, and then
slide support-hanging basket forward
to remove from back shelf rod.
3. To remove shelf grommet, slide
away from wall, then pull from rod.
4. Repeat steps 1-3 for other side.
5. With the shelf installed, press the
2 shelf grom -
mets down onto
the rod that is
anchored into
the appliance
wall (located in
the back only).
Be sure to keep
the larger end of the shelf grommets
away from the wall.
6. Push the shelf
grommets onto
the shelf rod until
firmly seated.
7. Slide the shelf
grommets into
the wall grom -
mets already in
the unit wall until
they are flush.
8. Guide the
support-hanging
basket underneath the shelf, insert-
ing the slotted end of the support
To install the handle clips to the basket:
1. Place the basket on a firm,
flat surface.
2. With the nar-
row side of the
handle clip on
the inside of the
basket, snap the
handle clip to
the recessed area in the basket.
3. Once the inside
surface snaps in
place, continue
the process by
rolling the han -
dle clip slightly
outward and
pressing down
firmly to snap
onto the outside
surface. If installed incorrectly, the
handle clip will not lay flat.
onto the rear
shelf rod.
9. Rotate the sup-
port-hanging
basket up to
bring the front
end over the
front shelf rod.
Slide forward to locate front of
support-hanging basket over front
of shelf rod. Push down on support
until it snaps into place.