Kenmore 15, Инструкция по эксплуатации, Страница: 16 / 36

INSERTING AND REMOVING THE MATERIAL
For all kinds of sewing, consult chart page
5.
Before placing the material on the machine
see that:
* The presser foot and needle clamp screws
are both tight.
* The sizes of the needle and thread suit the
kind of work to be done.
* The needle and take-up lever are at their
highest position.
* The tensions have been properly adjusted.
* The ends of threads have been drawn
about 4 inches to the rear of the
machine.
* The feed dogs are up.
Place material under the presser foot, insert
the needle into the material by turning the
hand wheel toward you, lower presser foot
and start sewing. Experiment by sewing on
the fabric to be used to determine tension
adjustment and correct stitch settings.
To remove the work, first turn the hand
wheel toward you until the needle is at its
highest position, then raise the presser foot,
draw material to the rear and cut off excess
thread with the thread cutter located on the
presser bar. To avoid sewing off the end of
the material, back tack each seam. See page
11.
IMPORTANT: Always turn the hand wheel
toward you! When the machine is not being
used, place a piece of material over the feed
dog and lower the presser foot. Always have
fabric under the presser foot when operating
the machine. Operating threaded machine
without fabric will cause it to jam by forcing
thread lint into the shuttle. See pages 28 &
29.
14